Nissan 370Z Forum - Hard to get in gear

Page 2 of 2

Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)

- Engine & Drivetrain (http://www.the370z.com/engine-drivetrain/)

- - Hard to get in gear (http://www.the370z.com/engine-drivetrain/125372-hard-get-gear.html)

Joe@ZSpeed

01-17-2018 11:34 AM

Quote:

Originally Posted by OldFart (Post 3722653)

I have a similar issue getting into 5th, but that was after the dealer had just installed a new CSC. I haven't gotten underneath the car, but isn't there an adjustable "stop" for the shifter? If I am careful, goes in smoothly, but if I just push it into 5th, seems like I go past the engagement point. Prior to that I wasn't having any issues except for the 1st to 2nd shift when cold...

This is an easy fix, Remove boots on top, You will find a steel plate with 3 bolts, Loosen bolts, put in 5th gear
Push plate up to shifter and tighten bolts. Or just take it back to dealer and make them fix it since they messed it up ;)

cjwsrt6

02-19-2018 11:13 PM

Wanted to bring the thread back up. Haven’t driven it much since I’ve gotten a beater but it shifts smoother, much easier in gear except when running it past say 5grand. It becomes very hard to get in gear and may grind slightly. Also when the clutch is coming back up I notice the pressure isn’t as strong. I was thinking about dropping it off and getting it re bled, hoping it’s that easy. If anyone’s had this issue please post up

cjwsrt6

03-04-2018 07:09 PM

Up. Just wanted to check on any thoughts before I turn it to my mechanic next week

TreeSemdyZee

03-04-2018 09:51 PM

I’d been having a similar problem for a long time and I finally bled the master cylinder and it works much better now. Not perfect, but I may need to do it again or replace it.

All times are GMT -5. The time now is 10:50 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page