Low washer Fluid Warning
 

installed Nismo CAI 2 years ago and did the relocate of washer resevoir as required by kit and light keeps coming on saying low fluid but is full and pump/motor is getting power and works...just some reason not detectiong fluid...any idea or can it be reset or cleared? Just now getting around to asking about this, Thanks. MEZ

Installed the level sensor backwards?

Disconnected wire?

You must have checked the obvious before posting this?

only 2 wires as i remember... 1 hot 1 ground?

The sensor maybe stuck in the low level position.

You can check if there is any debris and blow it out with compressed air

If not get it replaced.

You can get to it by simply removing the wheel, and pulling the wheel liner.

Maybe a pia though. :ugh2:

the bottle is moved to near center front. but thanks will check wires, then for debris.