Diff just started whining!

Optimiser · 10-31-2016, 09:58 PM

Hi all.
I have a Cusco LSD with 4.08 gearing and had it all rebuilt with new bearings, etc, a couple of years ago including new Whiteline bushes that support it. It has been well serviced as far as oil changes go and when it had just been done there was a little bit of whining which went away after a few months as it "ran in" I guess. It has been nice and quiet till now. I very recently did a (long) bit of wheel spinning in the wet over a fairly long distance under quite a few revs and it has now suddenly started whining pretty loudly, much more than it ever has. Could something have moved or failed with it's internals?

Regards.

roadie · 11-01-2016, 12:19 AM

Check for diff fluid leaks, may be running dry?

Sent from my SM-N920T using Tapatalk

Optimiser · 11-01-2016, 01:43 AM

Thanks for your reply and I will check that.

roadie · 11-01-2016, 01:44 AM

No problem, my Titan had that problem, but the diff didn't have a bolt, just plugged with sealant from factory. I'm sure the Z has a drain bolt but maybe it came loose or is gone.

Sent from my SM-N920T using Tapatalk

Optimiser · 11-01-2016, 02:38 AM

God I don't think so and hope NOT!
No leaks !

Optimiser · 11-02-2016, 06:49 AM

Has anyone got any proper input?

Masterbeatty · 11-02-2016, 07:47 AM

Change the fluid with a good synthetic oil. Check the magnetic drain plug for debris. When you drain the fluid starin it and look for chunks of metal. There should be some metal on the plug but if there is a lot then there is probably something wrong. If you were doing a long standing burnout then you might have over heated it. If the whine is there after then take it in.

Optimiser · 11-02-2016, 06:58 PM

Thanks for that and yes I've taken the car to my mechanic to have it checked out.

BGTV8 · 11-03-2016, 01:49 AM

Did you do a roll-back ??

eg: reverse back, car moving backwards, select first and dump the clutch for a spec'cy launch ??

Shock loads might have chipped a tooth on the ring-gear.

Check for something more than just filings against the oil drain plug.

Alternative is to stick a bore-scope inside the diff and check the teeth faces ....

Sudden change in noise in the diff is rarely good news (but you might create history).

Optimiser · 11-03-2016, 02:13 AM

LOL, no roll back, although I did some great ones in my Mum's Datsun 180B many years ago and broke nothing.

I dropped the car off at Revzone (who do all my work) this morning and they have just rung me to say the noise occurs in neutral as well so they will be dropping the diff for a proper inspection. I'm sure it's not leaked any oil and is running dry. Perhaps a bearing has failed?

Thanks for the feedback BGTV8 as it's all still very interesting to me.

jchammond · 11-03-2016, 05:09 AM

as mentioned,i'd change oil & inspect fluid that comes out.(for metal or shiny look) can even send off & get an oil analysis.
Be sure & use an oil that has the friction modifier in it for the clutches...

BGTV8 · 11-03-2016, 05:43 AM

Quote:

Originally Posted by Optimiser

LOL, no roll back, although I did some great ones in my Mum's Datsun 180B many years ago and broke nothing.

I dropped the car off at Revzone (who do all my work) this morning and they have just rung me to say the noise occurs in neutral as well so they will be dropping the diff for a proper inspection. I'm sure it's not leaked any oil and is running dry. Perhaps a bearing has failed?

Thanks for the feedback BGTV8 as it's all still very interesting to me.

Sooo .... your's was the grey rocket at Molan Street today ......... I was in there checking on my engine build around lunchtime ........ still sorting all the details of dummy assembly ..........

Be interested in the diagnosis in the end ..........

Optimiser · 11-03-2016, 05:47 PM

Quote:

Originally Posted by BGTV8

Sooo .... your's was the grey rocket at Molan Street today ......... I was in there checking on my engine build around lunchtime ........ still sorting all the details of dummy assembly ..........

Be interested in the diagnosis in the end ..........

Why yes it was! The filthy one that needs a wash.

Yes I will post here on what the diagnosis is.

Optimiser · 11-08-2016, 12:50 AM

A few days before the whining started I drove over what turned out to be a piece of square steel tube about a foot long that I thought I would clear! Big FAIL!!! I went over it right in the middle of the car and there was a couple of big horrific bangs! The car kept driving normally and there were no new noises. I has a look underneath and saw that the rear tunnel brace was a little damaged and a small dent in one of the exhaust pipes. After an inspection by my mechanic I'm told that it appears that the end of the tail shaft/front of diff was hit by it. This has somehow damaged the front diff bearing which is now causing the whining noise after a few days. A small camera was poked into the diff and the crown wheel and pinion appear ok, but the diff will have to be taken apart to fully check, have the bearing replaced and anything else that may be damaged and then all rebuilt again. The drive shaft itself will also need to be checked and possibly rebalanced.
I would have never called this!

BGTV8 · 11-08-2016, 02:30 AM

Good you got to the bottom of it ............

10-31-2016, 09:58 PM	#1 (permalink)
Optimiser Enthusiast Member Join Date: Mar 2013 Location: Australia Posts: 455 Drives: 2012 Nissan 370Z MT Rep Power: 20144	Diff just started whining! Hi all. I have a Cusco LSD with 4.08 gearing and had it all rebuilt with new bearings, etc, a couple of years ago including new Whiteline bushes that support it. It has been well serviced as far as oil changes go and when it had just been done there was a little bit of whining which went away after a few months as it "ran in" I guess. It has been nice and quiet till now. I very recently did a (long) bit of wheel spinning in the wet over a fairly long distance under quite a few revs and it has now suddenly started whining pretty loudly, much more than it ever has. Could something have moved or failed with it's internals? Regards.

11-01-2016, 02:38 AM	#5 (permalink)
Optimiser Enthusiast Member Join Date: Mar 2013 Location: Australia Posts: 455 Drives: 2012 Nissan 370Z MT Rep Power: 20144	God I don't think so and hope NOT! No leaks ! Last edited by Optimiser; 11-01-2016 at 06:56 PM.

11-02-2016, 06:49 AM	#6 (permalink)
Optimiser Enthusiast Member Join Date: Mar 2013 Location: Australia Posts: 455 Drives: 2012 Nissan 370Z MT Rep Power: 20144	Has anyone got any proper input? Masterbeatty likes this.

11-02-2016, 07:47 AM	#7 (permalink)
Masterbeatty A True Z Fanatic Join Date: May 2012 Location: Whales Vagina Posts: 4,586 Drives: the speed limit... Rep Power: 122867	Change the fluid with a good synthetic oil. Check the magnetic drain plug for debris. When you drain the fluid starin it and look for chunks of metal. There should be some metal on the plug but if there is a lot then there is probably something wrong. If you were doing a long standing burnout then you might have over heated it. If the whine is there after then take it in. __________________ 2011 MB 6MT Masterbeatty journal

11-03-2016, 05:09 AM	#11 (permalink)
jchammond A True Z Fanatic Join Date: Nov 2014 Location: South Carolina Age: 58 Posts: 15,204 Drives: 13’ 370Z TS 7A/T Rep Power: 2684394	as mentioned,i'd change oil & inspect fluid that comes out.(for metal or shiny look) can even send off & get an oil analysis. Be sure & use an oil that has the friction modifier in it for the clutches... __________________ MazWorx built long block \| FI-TT-100 Stage 2.75 \| IPT built 7A/T http://www.the370z.com/members-370z-...s-musings.html

11-01-2016, 12:19 AM	#2 (permalink)
roadie Base Member Join Date: Aug 2016 Location: Redlands, CA Posts: 42 Drives: Honda Ridgeline Rep Power: 9	Check for diff fluid leaks, may be running dry? Sent from my SM-N920T using Tapatalk

11-01-2016, 01:43 AM	#3 (permalink)
Optimiser Enthusiast Member Join Date: Mar 2013 Location: Australia Posts: 455 Drives: 2012 Nissan 370Z MT Rep Power: 20144	Thanks for your reply and I will check that.

11-01-2016, 01:44 AM	#4 (permalink)
roadie Base Member Join Date: Aug 2016 Location: Redlands, CA Posts: 42 Drives: Honda Ridgeline Rep Power: 9	No problem, my Titan had that problem, but the diff didn't have a bolt, just plugged with sealant from factory. I'm sure the Z has a drain bolt but maybe it came loose or is gone. Sent from my SM-N920T using Tapatalk

11-02-2016, 06:58 PM	#8 (permalink)
Optimiser Enthusiast Member Join Date: Mar 2013 Location: Australia Posts: 455 Drives: 2012 Nissan 370Z MT Rep Power: 20144	Thanks for that and yes I've taken the car to my mechanic to have it checked out.

11-03-2016, 01:49 AM	#9 (permalink)
BGTV8 A True Z Fanatic Join Date: Dec 2009 Location: 03350 Australia Posts: 1,514 Drives: 09 Nissan 370Z M6 Rep Power: 39973	Did you do a roll-back ?? eg: reverse back, car moving backwards, select first and dump the clutch for a spec'cy launch ?? Shock loads might have chipped a tooth on the ring-gear. Check for something more than just filings against the oil drain plug. Alternative is to stick a bore-scope inside the diff and check the teeth faces .... Sudden change in noise in the diff is rarely good news (but you might create history).

11-03-2016, 02:13 AM	#10 (permalink)
Optimiser Enthusiast Member Join Date: Mar 2013 Location: Australia Posts: 455 Drives: 2012 Nissan 370Z MT Rep Power: 20144	LOL, no roll back, although I did some great ones in my Mum's Datsun 180B many years ago and broke nothing. I dropped the car off at Revzone (who do all my work) this morning and they have just rung me to say the noise occurs in neutral as well so they will be dropping the diff for a proper inspection. I'm sure it's not leaked any oil and is running dry. Perhaps a bearing has failed? Thanks for the feedback BGTV8 as it's all still very interesting to me.

11-08-2016, 12:50 AM	#14 (permalink)
Optimiser Enthusiast Member Join Date: Mar 2013 Location: Australia Posts: 455 Drives: 2012 Nissan 370Z MT Rep Power: 20144	Update on diff whine diagnosis: A few days before the whining started I drove over what turned out to be a piece of square steel tube about a foot long that I thought I would clear! Big FAIL!!! I went over it right in the middle of the car and there was a couple of big horrific bangs! The car kept driving normally and there were no new noises. I has a look underneath and saw that the rear tunnel brace was a little damaged and a small dent in one of the exhaust pipes. After an inspection by my mechanic I'm told that it appears that the end of the tail shaft/front of diff was hit by it. This has somehow damaged the front diff bearing which is now causing the whining noise after a few days. A small camera was poked into the diff and the crown wheel and pinion appear ok, but the diff will have to be taken apart to fully check, have the bearing replaced and anything else that may be damaged and then all rebuilt again. The drive shaft itself will also need to be checked and possibly rebalanced. I would have never called this! Last edited by Optimiser; 11-08-2016 at 01:03 AM. Reason: Additional content.

11-08-2016, 02:30 AM	#15 (permalink)
BGTV8 A True Z Fanatic Join Date: Dec 2009 Location: 03350 Australia Posts: 1,514 Drives: 09 Nissan 370Z M6 Rep Power: 39973	Good you got to the bottom of it ............

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[FOR SALE] OEM VLSD diff and diff cover	FireDan50	Parts for sale (Private Classifieds)	6	05-09-2015 04:03 PM
manual diff and auto diff	reldas	Engine & Drivetrain	3	02-02-2015 03:39 AM
whining	jcole8188	Nissan 370Z General Discussions	7	09-24-2013 05:50 PM
WTT: My Base Diff + Cash for Your Sport Diff	aadosx	South East Region	0	04-27-2011 06:41 PM
WTT: My Base Diff + Cash for Your Sport Diff	aadosx	Parts for sale (Private Classifieds)	11	04-27-2011 06:40 PM