Fuel Pump Relay - Does anyone sell a harness kit to avoid cutting OEM wiring?
 

Just like the title says... does anyone make pigtails to connect to the OEM connectors (like an extension for the OEM Harness -> Fuel pump connection)? I always hate the idea of cutting or splicing my OEM wiring harness.

In case anyone is wondering... My 255lph pump and 600cc injectors are pretty much maxed out in my TT application... Next time I am anywhere near my tuner (JTRAN in Houston, TX) I want to upgrade to a 340lph and 1000cc injectors for the safety margin....and maybe a few extra ponies if I am lucky. I'm pretty sure I'll need to upgrade the wiring at that time too as the Aeromotive 340 draws a good bit more current than the Walbro.

The manufacturer of the fuel pump connector never produced a male counterpart that would plug into it. They do for every other connector in the series, but not the 5-pin.

Thats not to say that you cannot accomplish it without cutting wires, but an easy plug an play is not possible.

If you insist on keeping the OEM wires intact, you can de-pin the factory 5-pin connector, and apply the original pins to different connectors of the same series.. such as a 2 pin and a 3 pin, or a single 6 pin, and then make a PnP harness for that/those connectors as the male counterparts are available.

That's a bummer... I'll probably just cut or tap as necessary. Thanks for the information! Your posts are always great.