(MT) Ignition Point for Clutch Pedal

[jburch]

Just a precaution I'm trying to watch out for. I recently replaced my clutch because of CSC failure and went ahead and upgraded while the transmission was dropped. I also recently found out that the clutch doesn't need to be pushed to the floor when going in & out of gears. Because of my previous car's clutch engaging at the bottom, I always did this with my Z. Which may be the reason my CSC failed. (Sorry about the lack of engagement knowledge, being that i'm only 18.)

Anyways, So I got a stage 3 clutch kit w/ HD CSC and daily driving as been becoming a PITA. To help I purchased the RJM Clutch Pedal Assembly. So basically the whole point of the post is that pushing clutch to floor I bad for the CSC (At least from what I've heard). So to fully eliminate me having to push the clutch to the floor I've been driving while only pushing in the clutch in right past engagement point (A little over an inch). The only persisting problem is that to start my car, the pedal has to be fully depressed, which supposedly isn't good for the CSC. So is there anyway to change/bypass the position of the "Ignition Point" for the clutch pedal? Would really appreciate some positive feedback, I don't post that much but want to become an active member down the road.

Thanks, Jacob