Throttle Sticking

Dragon_Ball_Z

Hey guys, I recently had my CSC swapped and the dealer left off the intake tube off my Stillen gen 3's. I went to pick up my car and it sounded cammed. It threw idle codes and mass air circuit codes. They cleared the codes and put the intake on properly, reset the ecu and the car runs fine. After 100 miles or so i have been noticing that after my car reaches 180 degrees on operating temp, the throttle will lag and start to stick. For example, first gear i shift at 3k it will stay at 3k for a second and then drop. It starts doing this after about 20 minutes of driving. It is very noticeable in first gear only. The maf sensors i have cleaned and it didn't fix the problem. My mods are stillen gen 3s, berk hfcs, and a fast intentions exhaust with 18" resonators. I also threw the codes p2098 and p2096 after they replaced the csc. the codes are popping up every 100 miles. I am untuned. Any ideas on how to fix this throttle sticking issue? The car is a 2014 sport touring with 10k miles on it.

__________________
Build in Progress