Concept Z Not Standing By Their Product
 

So i spent almost 1200 with concept Z on a new Stage 2 clutch and HD CSC for my car that was in the shop for the warranty long block replacement. finally after 5 weeks of sitting at the dealer they get to the motor and put everything back together to find out that the bleeder nipple valve won't hold fluid. I call Concept Z and speak with Coz who says he would be happy to speak with the service adviser about the issue and see what we can do. Come to find out that there were some known issues with the bleeder valve leaking. unfortunately i got one that was machined incorrectly at the female side where the bleeder valve screws in thus i have a bad unit. So here is where the debauchery begins.

I call Concept Z and speak with Coz who tells me that the dealer and the manufacture (ZSpeed Performance) are in talks with each other to resolve the issue. I asked Coz can they maybe send out a new one since it was defective and he tells me that its no longer their issue its the manufactures issue.

Im sorry but I bought a defect product from you not from the manufacture. why am I already going back to the manufacture on something that I purchased through you no less than 2 weeks ago. I had a Nissan factory trained technician install the part so it is of no fault of mine or the dealer in this instance. What's bad enough is now i have to spend an additional $800 to have the tech take the tranny out and put ANOTHER csc that is not defective. To me this is terrible customer service for someone that just spent over $1100 with them and didn't damage the product during installation.

If i get a defective toaster from Walmart they are more than willing to replace it for another and not tell me to go to Black and Decker to fix it.

Im very dissapointed in Concept Z at this point and will probably not purchase from them again.

That sucks, yelp it

I hope forum admin can step in and assist you with your issue with Concept Z and have a mutual resolution. Try to pm them.
Since they are a vendor over here.

I cant speak for ConceptZ, but I do know Joe and he is a stand up guy. You should give him a call honestly.

I hope you can resolve this soon and not to be an *** but why did you went with ConceptZ and not with Joe at zspeedperformance directly? He has great customer service and i am pretty sure he would had help with what you needed to begin with.

I had the same issue with the bleeder nut... my tech had to muscle it. Is there some way these things can be replaced with something better or is it permanently attached to the braided hose?