Condenser connection
 

I am in dying need of getting a clear picture of the two connector on the right side of the radiator, one connector goes to the hood latch and rhe second one goes to the condensor dryer, this car was in an accident and these connectors got smashed, need to joint the cables but the colors are different, any help will be appreciated, could send me a pic 7322136158

Anyone?
 

All i need is to match the colors on the wires. Between the condensor dryer pigtail and the car hardness.

The FSM has wiring diagrams, pinouts, wire colors, &c.

thanks for trying to help, but what I can find is that it only list the colors up to the connector that snaps to the pigtail in the pressure sensor, but it does not state to what colors it matches to.

If it's a switch (I think you are talking about a pressure switch), then there is no polarity - wire it up either way and it will work.

Yes but it has three wires going to it Violet, Blue, beige. I have identify that the beige is the +5volts, the blue is signal to the ecm and the violet is the ground. The problem is that this cables connect to a pigtail that goes to the pressure sensor which the colors change to red, black and blue. Need to match them

Get an ohmmeter. Should be zero ohms between one of the switch wires and ground - infinite ohms between other wires and ground. Other wires should swap between zero and infinite ohms as the switch makes/breaks.