CJM Oil Pan

phunk · 05-30-2015, 09:42 PM

Quote:

Originally Posted by Spooler

LOL, we think alike. That is what I was going to do with it and then clear over it.

If you do decide you want to make it 2-tone like that by painting or powder coating and then sanding, let me know because you would want it un-anodized to start with. You wont want to have to sand through anodizing, its much harder than the aluminum and soaks into the surface as well. It would be a nightmare to sand through it!

Spooler · 05-30-2015, 09:43 PM

Quote:

Originally Posted by phunk

If you do decide you want to make it 2-tone like that by painting or powder coating and then sanding, let me know because you would want it un-anodized to start with. You wont want to have to sand through anodizing, its much harder than the aluminum and soaks into the surface as well. It would be a nightmare to sand through it!

Ah, just make it Nismo red the best you can. I dare to be different.

phunk · 05-30-2015, 09:45 PM

Quote:

Originally Posted by Spooler

Ah, just make it Nismo red the best you can. I dare to be different.

LOL I will tape a picture of your car on it with a note asking to please match the best they can!

I dont mean to be difficult with you, I am just trying to make sure that what arrives in your hands is what you were expecting!

Spooler · 05-30-2015, 09:53 PM

Quote:

Originally Posted by phunk

LOL I will tape a picture of your car on it with a note asking to please match the best they can!

I dont mean to be difficult with you, I am just trying to make sure that what arrives in your hands is what you were expecting!

My car is MB.....LOL I am good with whatever RED color comes out. A little darker is fine. I am not going to be that picky about it. Getting everything to color match is just about impossible. NO worries from me.