No communication from transmission
 

Quick help please.

Did a clutch flywheel with csc etc install for a friend.

Car cranks but states no communication with transmission on my scan tool.

Where should I look?
Just getting into Nissans.

Thanks for your help.
I did a search and didn't find any info on the first seven pages and I am unable to open the manual on my phone.

Sounds like you missed some connections on the wiring harness.

Any where I should look in particular or any fuses/relays?

Thanks

I would check all the plugs on the transmission harness. The 2 on the drivers side above the transmission brace/mount would be good canidates for not getting them seated well. im not sure if the crank position sensor gives that fault but, i would make sure that has been reinstalled too.

Crank sensor was dying on it.
Replaced. Same result of not starting.

Any ideas?
Thanks in advance.

Do you have the service manual? I'm not sure which model year you're working on, but please browse here if you need to get the service manual:
Nissan 370Z Owners Manual / Service Manuals - Nissan 370Z Forum

check those connectors, People tend to push the clips in on the connector, then pull on the whole wiring harness. (not saying you did this) but maybe a pin came out of the connector

Sounds good. I didn't remove the clips so that could be it. I hope that is it.
My issue with the service manual is how tiny the diagrams are on my iPhone. I need to get a new laptop here soon. Lol.
Thanks Mates.