|
Originally Posted by ///PureSwank Why can't a vendor just get the exact dimensions of the oem panels and then just manufacture it according to those measurements? Sent from my SM-N900P
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-27-2014, 01:06 PM
|
#13 (permalink) | |
|
A True Z Fanatic
Join Date: Sep 2009
Location: Mod Capital of Canada
Age: 58
Posts: 7,354
Drives: cars. lots of cars.
Rep Power: 40182   |
Quote:
Because not every car fits the same! Each car is a little bit different on the lot. Add to that the fact this is a manufacturing process for Fiberglas and you can have small changes in dimensions and fit that need to be adjusted during body prep. This is nothing new. It has always been like this in adding body kits. Some kits fit better than others but all need minor prep. Sent from Canadia
__________________
 H&R / Stillen / Berk / HKS / Swift / Michelin / UpRev / SPC / Amuse Rep / Seibon / Fringe XVO / TWM / more... My Journal |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pic Request: Fujimura front bumper w/ Amuse rear bumper | Wonka2581 | Exterior & Interior | 10 | 04-26-2013 06:43 AM |
| Amuse bumper only | gthausz | Exterior & Interior | 8 | 10-20-2012 07:46 PM |
| CS Amuse or Amuse Rear Bumper in General Q. | FastPaced | Exterior & Interior | 6 | 08-22-2011 03:23 PM |
| AAM Short Tail with Amuse bumper install | Z Monster | Intake/Exhaust | 0 | 04-28-2011 04:23 PM |
11Likes
Threaded Mode
