|
Well finally did this. My OCD wouldn't allow me to have just one switch and two blank panels, so I ordered three switches. Also my OCD needs to have the
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
06-09-2017, 09:33 AM
|
#11 (permalink) |
|
Enthusiast Member
Join Date: Nov 2016
Location: Ohio
Posts: 261
Drives: 2016 370Z
Rep Power: 953   |
Well finally did this. My OCD wouldn't allow me to have just one switch and two blank panels, so I ordered three switches. Also my OCD needs to have the switches in the same direction, so the switch for the yaw sensor is backwards, as normally most accessories would not be on all the time:
 I always de-insulate the terminals so I can solder after crimping. Just a habit from my Jeep I guess, so I re-insulate them with heat-shrink afterwards:  At least there is lots of areas underneath to keep the wires out of the way:  I think with three switches it looks OEM: 
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Yaw sensor switch | dimitarm | Exterior & Interior | 33 | 08-09-2017 10:13 PM |
| YAW Sensor Rocker Switch | dP3NGU1N | DIY Section (Do-It-Yourself) | 23 | 11-10-2013 05:57 PM |
| Viper Security System/Tilt sensor/Proximity sensor | kfull | Nissan 370Z General Discussions | 4 | 04-27-2012 12:10 AM |
| Installed the Rocker Stripe (pic) | kent370 | Member's 370Z Gallery | 9 | 02-15-2012 03:30 PM |
| Rocker panel chips? | JGreenwood07 | Exterior & Interior | 2 | 07-14-2010 10:58 AM |
84Likes
Threaded Mode
