11-10-2014, 11:46 PM
|
#11 (permalink)
|
|
Enthusiast Member
Join Date: Oct 2010
Location: Sun Shining State
Posts: 294
Drives: A Starship
Rep Power: 15
|
Quote:
Originally Posted by AdamRacer
I followed your thread and video when doing mine and it helped a ton.
Mine came out great but after a few week's I had a minor issue that happened. Not sure if this had anything to do with it but my car was outside all day. So I noticed there was a spot that became foggy on the inside of the lense. It wasn't moisture because I added extra sealant and it was definitely sealed. The next weekend I opened them back up to clean the foggy area and it had eaten off the clear film on the inside of the lense. Its not noticeable unless your looking for it in the direct sun but its weird how it happened.
Any ideas why this would happen? Anyone else experience this with your lense?
|
Yes it happened to me, from cleaning the inside of the lens. I had to restore the inside of the lens, very easy use 2000 grit in one direction, then use 3000 grit across the direction you went with on the 2000 grit, then a few drops of plastic x with a powerball connected to a drill, I also used a light spray of lubricant for HL restore to keep the powerball from drying up. Good luck, hope you get it fixed.
|
|
|
Similar Threads
79Likes
Threaded Mode
