11-07-2014, 02:07 PM
|
#10 (permalink)
|
|
Enthusiast Member
Join Date: Oct 2010
Location: Sun Shining State
Posts: 294
Drives: A Starship
Rep Power: 15
|
Quote:
Originally Posted by AdamRacer
Well as far as cleaning the inside of the lense I didn't use anything harmful just some microfiber cloths and water. To make a suggestion to others what I think happened is I did the whole process too quickly. What I mean by that is I opened them up early in the morning, took them apart, prepped and sprayed, and resealed them that night. I think the issue of that process was not allowing the paints to dry for a full 24 hours as most paint instructions call for. I let them dry for a little longer than a "dry to touch" timing (I'd say about 5 hours). The paint may have let off some chemicals as gases when baked to reseal since it wasn't fully dry. That's the only thing left I can think of. So if you're doing your lights I would suggest waiting a whole day before resealing them.
|
You know I was thinking that myself, the chemicals released in the gases combined from the goop and the paint might have caused the protective film to corrode or wear/haze on the inside if there is any. What paint did you use? Then again the $$$$ "pros" do it in less than a day. Either way I plan on finishing these tonight!!!
Edit: Not tonight, no way as much as I wish, I'd rather have it done right, did some trial and error...mainly error ------ paint both housings at the same time before reassembling,...why the second one came out darker than the first which I had already sealed  ....  I like the darker one...
Last edited by 370zHawaii; 11-07-2014 at 05:04 PM.
|
|
|
Similar Threads
79Likes
Threaded Mode
