DIY: Headlight LED's and blackout

Caravanshaka · 06-29-2009, 10:13 PM

Quote:

Originally Posted by DIGItonium

I'd prefer epoxy over hot glue because it tends to get soft especially in this 100 deg. weather and direct sunlight. Sweet job! I don't have the time and guts to pull apart my headlight assembly.

Epoxy isn't a bad idea to use for mounting. A little more permanent might not be a bad thing

All of the LED's (except that 3rd one from the bottom) fit in there pretty snug without the glue, so I don't foresee any problems with it. Epoxy is a good alternative if you are a little uncomfortable with hot glue.

Time wasn't too bad, I could do a second set in about 6-7 hours...but it definitely takes guts, and it was still nerve racking!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: Headlight Removal	DIGItonium	DIY Section (Do-It-Yourself)	34	09-03-2017 08:01 PM
180 Custom Headlight Review!	bullitt5897	Exterior & Interior	43	12-10-2010 05:26 PM
Blacked out headlight for PG !!!	msl82	Exterior & Interior	31	05-02-2009 06:06 PM
Blacked out headlight	msl82	Nissan 370Z General Discussions	6	01-02-2009 12:47 PM