|
For those having issues with the bolt spinning / loctite, here's what I did: spray the nuts with some PB Blaster. Let it sit for about 30 seconds. Then take
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-14-2012, 06:52 AM
|
#11 (permalink) |
|
Track Member
Join Date: Aug 2011
Location: New Castle, Indiana
Posts: 764
Drives: '12 370Z
Rep Power: 55   |
For those having issues with the bolt spinning / loctite, here's what I did: spray the nuts with some PB Blaster. Let it sit for about 30 seconds. Then take your 10mm and do a quick / hard turn on the nuts to break the (now softened) loctite. Both of mine spun right off doing this. Less than a minute to remove it.
I'd normally break loctite with a wrench / hammer combo, but I couldn't get a hammer in there. A quick turn should accomplish the same thing. The key is, you have to do this first, not after you've jacked with them and spun the head. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fog Lamp install with DIY harness question | wdkwang | Exterior & Interior | 10 | 03-02-2015 01:02 AM |
| Install of Stillen G3 Intakes complete - review, etc. | semtex | Intake/Exhaust | 83 | 06-23-2010 12:19 PM |
| Forged Performance: TEIN Flex Install 370Z Complete | Sharif@Forged | Brakes & Suspension | 37 | 02-19-2010 03:51 AM |
| Install complete ( Finally ) Item list, Cost, Time | 355890 | Audio & Video | 11 | 06-28-2009 11:14 PM |
13Likes
Threaded Mode
