|
hey how do you remove rear bumper cause i dont have room in my garage cause i got a couple bikes in there and i plan on painting the front
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
05-17-2012, 06:18 PM
|
#1 (permalink) |
|
Base Member
Join Date: May 2012
Location: Georgia
Posts: 5
Drives: 11 Nissan 370z CT A7
Rep Power: 13  |
how do you remove rear bumper?
hey how do you remove rear bumper cause i dont have room in my garage cause i got a couple bikes in there and i plan on painting the front and rear bumper fangs?
|
|
|
|
05-17-2012, 06:58 PM
|
#2 (permalink) | |
|
Administrator
Join Date: May 2009
Location: Disneyland, Ca
Posts: 8,732
Drives: 🔰
Rep Power: 10  |
Quote:
The same for the front bumper  
__________________
  Last edited by Trips; 05-17-2012 at 07:03 PM. |
|
|
|
|
|
05-17-2012, 09:00 PM
|
#4 (permalink) | |
|
A True Z Fanatic
Join Date: Aug 2011
Location: Laguna Beach, CA
Posts: 2,214
Drives: Nismo Z
Rep Power: 3066 |
Quote:
There's a bolt inside the rear fender, 2 bolts underneath near the mufflers linking to the body, pop off the little black tabs next to the taillight when the trunk is open and unscrew those then there is like 5 plastic clips behind the portion above the license plate inlet, also clips that slide in the bracktes attached to the bumper....just pull MAKE sure to painters tape off your rear quarter panels before taking off! Lastly to be 100 percent sure you have all bolts go to courtesy nissan parts and print out the sheet that breaks out ALL parts for the rear... This will give you an idea on where ALL bolts-clips are I did mine on my 350z and it was fairly easy to do
__________________
AMUSE * TOMEI * STILLEN * CRAFTSQUARE RECARO * 3M * TOP SECRET * SLICKCARBON |
|
|
|
|
|
05-17-2012, 10:17 PM
|
#5 (permalink) |
|
A True Z Fanatic
Join Date: Dec 2009
Location: Tacoma
Age: 53
Posts: 2,496
Drives: Z34, R35
Rep Power: 20    |
Its PITA to remove it, you have to remove the rear interior panel pieces, and the two tail lights, then unclip all the snap in clips. I think some behind the fender liner too. Then she comes right out.
Better just tape it off if all your doing it painting the valence.
__________________
2009 370Z Monterey Blue,Nismo Conversion,RE-11's, K&N Typhoon intakes,Blue Kickplates,Homelink,FI 18" CBE,ERZ HFCs,Hotchkis sways, Swift Spec-R, EVO-R Highwing, UPREV 
|
|
|
|
|
05-18-2012, 02:51 PM
|
#6 (permalink) |
|
A True Z Fanatic
Join Date: Aug 2011
Location: Laguna Beach, CA
Posts: 2,214
Drives: Nismo Z
Rep Power: 3066 |
Or just get the carbon fiber pieces and dont worry about overspray or masking off all sorts of parts...
It isnt that bad pulling the rear bumper off but for what you are doing its a little over the top to pull the rear off for....
__________________
AMUSE * TOMEI * STILLEN * CRAFTSQUARE RECARO * 3M * TOP SECRET * SLICKCARBON |
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How Do I Remove the Front Bumper 2009 370Z | aragona7 | Exterior & Interior | 7 | 04-08-2013 05:56 PM |
| [FOR SALE] SOCAL: OEM PW Front Bumper/Rear Bumper/Side Skirts/Fenders | Fly1 Motorsports | Parts for sale (Private Classifieds) | 11 | 02-03-2012 07:17 PM |
| MB Front bumper, rear bumper and Side skirts | Jamaica | Parts for sale (Private Classifieds) | 9 | 12-22-2010 01:46 PM |
| FS:Stock Parts Black~Hood,Sideskirts,Front Bumper,Rear Bumper,Nismo Spoiler,Intakes | Tango | Parts for sale (Private Classifieds) | 19 | 10-04-2010 09:25 PM |
| Anyone know how to remove the front and rear Nissan emblims? | IIcovski | DIY Section (Do-It-Yourself) | 4 | 05-10-2010 10:19 PM |
Linear Mode
