Where can I tap into for rpm signal wire my datalogger (iq3) needs signal.... Thanks!

hmmm looks like i will be getting 2 more guages and doing this at a later date
got a boost gauge to go with the GTM SC install but if i am gonna bother sounds like i should do all three.

awesome info gang exactly what i wanted to know!!

Here is a link to my gauge install, used a very similar method to this DIY and changed a few things as I went.

http://www.the370z.com/members-370z-...ml#post2190300

very similar to the way I installed mine, i used a long piece of aluminum, drilled 3 holes and jb welded the lock nuts on. I find the fact that all 3 gauges are on the one long piece locks them all in place well

What kind of hook did you guys use to get the gauges out?

I used this set,

http://buy1.snapon.com/catalog/objec...8500/58430.JPG

Am I reading this correctly...the gauge clusters are 60mm and not 62mm. So the GReddy Multi D/A Gauges (62mm) won't fit? GReddy

You will be hard pressed to fit a 62mm gauge in the factory location. Depending on the depth of the gauge it could be done but will need extensive modifications. You also will lose the silver trim ring.

My gauges are 52mm and they were a tight fit.

https://farm9.staticflickr.com/8499/...ac4719e8_c.jpgIMG_8032 by J M Gale, on Flickr

Hm, damn. Thanks.

I really want multi gauges. More looking for me!

Bump for future reference

Hm. May have to go this route. If it is quick connect maybe I can pull it out at the track?

Edge Insight Multi-Gauge Display Monitor

Brute Force
 

When I replaced my useless triple meter w/Défis I just wedged my three big fingers under the plastic hoods, which is the darker plastic that touches the dash. Don't pull on the visors, they will break off easily from the hoods. Once you get your three big fingers wedged under the front (closer to the windshield) hood and dash, just pull back towards where you're seated like a mothafawker and the whole thing will give- hood, visor and probably the bezel too! No need to use hook/pick. Do @ your own hood/bezel risk! :icon17:

Attached is my demoed triple meter.
:icon18:

Part numbers for these POS:
Triple meter - 24845-1EA1A
Left hood - 68112-1EA0A
Center hood – 68113-1EA0A
Right hood – 68114-1EA0A
Bezel (all same) - 68236-1EA0A

Sub'd, great info


Sent from my iPhone using Tapatalk

To anyone using prosport gauges, how are they holding up?

Do you know which wire is the dimming wire for the factory gauge harness. Thanks

Phil