![]() |
Thanks Man..I found your added instructions very helpful. Just a general comment to the thread...Everything was as the instructions suggested...The driver side crank case venting outlet takes the two 3"
|
|
LinkBack | Thread Tools | Display Modes |
![]() |
#18 (permalink) |
Base Member
Join Date: Mar 2010
Location: Milton, GA
Posts: 247
Drives: 17 Nissan GT-R
Rep Power: 16 ![]() |
![]()
Thanks Man..I found your added instructions very helpful. Just a general comment to the thread...Everything was as the instructions suggested...The driver side crank case venting outlet takes the two 3" rubber tubing as a 90 degree setup..and that is a good fit. The instructions state to use the 7" tubing "as is" for the passenger side crank case vent. You just cannot install the 7" piece without a sever kink..As you stated it must be cut to size....Approximately 3" should do it...but measure first.
I immediately felt a difference in response and sound. A really good modification for the money and effort!!
__________________
2017 Pearl White GT-R Premium |Full Bolt-On E85 From Speed by Design| |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[FOR SALE] K&N Typhoon cold air | bigrob126 | Parts for sale (Private Classifieds) | 3 | 07-07-2011 03:00 AM |
FYI K&N Typhoon | dragonsoul198 | Intake/Exhaust | 17 | 06-02-2011 11:44 AM |
K and n typhoon 14.2hp ???? | ddvette9 | Intake/Exhaust | 3 | 03-21-2011 11:58 PM |
WTB K&N Typhoon CAI | Econ | Wanted | 0 | 02-25-2011 10:25 AM |
WTB: K&N Typhoon Intake | omgZ | Wanted | 0 | 01-18-2011 02:08 AM |