DIY OEM Shift Boot Install on Automatic

Baer383

Warning this mod is not for the light hearted it requires some grinding on the shifter housing & console piece.

Some of the pics aren't the best but for those of you able to do this can easily fill in the blanks.

After removing the silver cover you will see 4 clips that hold on the PRND plastic cover.

Here are the ones in the front.
After unclipping it just pull the black cover straight up and remove it.

You will see the little light with a bulb in it just pull it out and store it for later.

Here is where is gets tricky disassemble the shift boot and take the bottom piece and try to fit it over and you will see where it hits this is where you have to grind on the shifter housing.

You must also cut the bottom piece to fit(TRIM IT SLOWLY).
This is a little knob sticking off to the side just cut it off.
Take your time once all 3 pieces fit (the bottom to the console,the middle leather piece,and the silver trim ring)then just reassemble the boot assembly and install.

__________________
2013 ZL1

754 rwhp 747 rwtq