DIY: Greddy Turbo Aluminum Oil Pan as an additional oil cooling option

wind.zero · 09-06-2011, 08:58 AM

Quote:

Originally Posted by FAstGreg

Hi !

May I ask you the size of the oil drain hole and gauge hole of the Greedy oil pan ?

How do you welded the holes ?

Do the plastic engine under tray still fit with the Greedy oil pan ?

Thanks for avdise and help ! I would like to install it on a VQ35HR.

I am not sure of the drain hole/temperature gauge sizes. I know there were metric and my tuner tapped them to a standard thread size.

My tuner used a welder to seal off the turbo return ports. I guess you could use block off plates, but Kenny recommended welding them closed. Be sure your welder is familiar with working with aluminum.

I had no problems with the plastic engine under tray fitting because the Greddy pan does not sit any lower than the OEM pan. It is just wider on both sides.

Good luck.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Intense Cooling Specials! Beat the HEAT w/ Mishimoto, Koyo, Samco, Greddy and more!-	INTENSEPOWER	Drivetrain/Engine	39	08-29-2011 01:21 PM
Greddy Turbo TI-C or Greddy Spectrum Elite?	Andy124	Intake/Exhaust	32	06-05-2011 02:34 PM
Nismo - Greddy Turbo Ti-C	adidasboy1186	Intake/Exhaust	16	11-15-2010 10:58 PM
Greddy Tuner Turbo Kit - limited time special! - FREE Ti-C Greddy turbo exhaust!	GT Motoring	Forced Induction	2	07-17-2010 05:57 AM
Greddy Tuner Turbo Kit - limited time special! - FREE Ti-C Greddy turbo exhaust!	GT Motoring	Drivetrain/Engine	0	07-16-2010 07:26 PM