The best way to remove these bolts is to loosen it a little the tighten loosen more tighten and so on it helps keep the loctite from jamming up in the threads plus it will chew it up so to speak and make it easier to remove.

As far as tamper poof or not if he didn't have the tamper proof he wouldn't get on it.:hello:

This may be a stupid question, but I'm gonna ask anyway. How do you remove the front plastic (with the Z on it)? Does it just pop off?

That's part of the airbag assembly. It simply pulls out afteR you remove the two torx bolts and unplug th airbag sensors.

:tup:

Thanks for helping with answers guys I have had a lot of personal crap going on and not much time to get on here I will rep ya when I get to a computer one day.

mine got stripped no clue how to remove it-___-

What got stripped?

the first 2 torx screw-__-, shoved the t30 in tried to unscrew it, started stripping immediately.

Did you use the tamper proof torx bit? I soaked my screws with penetrating oil for about 15 minutes and used the tamper proof bits. Came out pretty easily.

yeah i did use the tamper proof ones,
i just went in there trying to unbolt it like a normal bolt it started stripping a bit inside >_<

Nice write-up.

Thanks 6MT

Calvin you will probably have to try an easy out if that does not work a good ole drill and tap set will be needed.

I had the same problem trying it by hand at first so I used a drill just to bump it hard once and they broke loose.

did that -__- drill wasn't strong enough,-__- lmfaooo

gonna finish up tmrw.

So you got them loose?

Hey Calvin any update on this? Someone could benefit one day possibly by what you had to do.