DIY: Oil Pressure Gauge

40 to 332

I agree. Perhaps you f'd the sensor during the course of blowing multiple fuses. You might try installing another new sensor ... now that the wiring problem appears to be solved.

filip00

That issue appeared with the old pressure sensor! That's why I replaced it in the first place. And the new one shows exact same behaviour. This is why I'm suspecting something might be wrong with the gauge itself...

__________________
ride epic drive epic

40 to 332

I'm not ruling out that the gauge itself may be at fault. However, my understanding is that when the problem first appeared with the old sensor, the fuse(s) were being blown. Then you installed the new sensor and the fuse(s) continued to blow. The new wiring scheme appears to have solved the problem with the fuses blowing. But both sensors suffered the blown fuses and both may have been f'd. So it could be that the sensors were damaged, leading to a wrong signal being sent to the gauge. Or, it may be that the gauge was damaged when the old wiring scheme was in place. I guess the choice becomes whether to replace the gauge and see if that solves the problem or install another new sensor and see if that works. I suspect the sensor would be the cheaper option.

filip00

You are completely correct in everything you said, and thanks for that!

I gotta say though - if I decide to again replace the sensor, I must go through the hassle of changing the oil again (or recirculating it), and that still might lead me to nowhere. Alternatively - if I go with the expensive option of checking the gauge - I can quickly check it, and if that isn't the solution - I can still return the gauge and get my money back. So I'm actually leaning towards that option....

__________________
ride epic drive epic

filip00

Ok, I just had another idea. I can always unplug the sensor from the pressure gauge and see if it dials to zero when turning on. If it doesn't, it's obviously the gauge problem.

__________________
ride epic drive epic

40 to 332

Agreed ... that's worth checking.

Alienpoker

I appreciate this is an old thread, and it’s a good write-up. I’m concerned that over tine you will get cracking where the adapter(s) connect to the block from vibration. My solutions would be:
1) Use a sandwich plate adapter at the oil filter with 1/8” Npt Fitting for the oil pressure sender. More expensive, but lots of options including Mocal.
2) If the warning light is just an ‘idiot light’ wired directly to the pressure switch, just replace that with a single Male-BSP to F-Npt converter (3036-02-02) https://shop.hoseandfittings.com/cat...13ac8c2&LINE=1
And put your pressure sender there. The idiot light would never light, but who cares if you have continuous pressure monitoring?

__________________
‘It’s like deja vu all over again’
2010 370Z Nismo Magnetic Blk 6MT
‘73 240Z White 2.6L 5MT