So i ordered in new seats with 5 point harness, i want to remove the factory seat belts, but they are tied in with the air bag system, It is
|
|
LinkBack | Thread Tools | Display Modes |
07-04-2010, 11:07 PM | #1 (permalink) |
A True Z Fanatic
Join Date: Dec 2009
Location: wpb, fl
Posts: 1,146
Drives: 09 370z
Rep Power: 17 |
Eliminate Seat Belt
So i ordered in new seats with 5 point harness, i want to remove the factory seat belts, but they are tied in with the air bag system, It is designed to tighten and lock when the airbags deploy. does anybody know what resistor needs to be put in the place of the seatbelt?
Thanks for eveybodys assisance!!
__________________
Best 1/4 mile 12.24 Best mph 114.5_______ |
07-05-2010, 01:28 AM | #2 (permalink) |
Administrator
Join Date: May 2009
Location: Disneyland, Ca
Posts: 8,732
Drives: 🔰
Rep Power: 10 |
Look in Here!
http://www.the370z.com/diy-section-d...light-fix.html |
07-05-2010, 06:33 PM | #5 (permalink) |
Grand Prix of Endurance
Join Date: Nov 2008
Location: Tennessee
Posts: 3,476
Drives: Mulsanne Straight
Rep Power: 26 |
Will the airbags deploy without the weight sensor in the new seats?
__________________
We can do without any article of luxury we have never had; but once obtained, it is not in human nature to surrender it voluntary. |
07-06-2010, 08:13 AM | #9 (permalink) | |
A True Z Fanatic
Join Date: Mar 2009
Location: Greenville NC
Posts: 2,883
Drives: 370Z Sport
Rep Power: 976 |
Quote:
Well......Is this gonna be a track car? Otherwise you'll find 5 point belts a real PITA for daily use......My suggestion would be to leave the stock belts functional while still installing the 5 points. This can be done with various hardware bits like Eyebolts etc sold by shops for this purpose..I did this a few cars back using clip in style belts, so only had them in and functional when I needed them. As far as the electrical end, you need to latch the stock belt to turn off the warning...there is a simple on/off switch in the latch so you can just complete that circuit to fool the system for when you're not using them.. On the seat airbags, you need to wire a 4.7OHM resistor across the wiring to provide a sufficient load for the car to THINK the airbags are still in the system..Like this: |
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can you kill the seat belt warning chime? | Pushing_Tin | Nissan 370Z General Discussions | 21 | 07-02-2014 11:18 AM |
Seat belt light | Red370 | Nissan 370Z General Discussions | 10 | 02-26-2010 10:23 PM |
installing a camera to eliminate blindspots | vehl | Exterior & Interior | 9 | 08-03-2009 11:23 PM |
Any ideas to eliminate squeak in hatch ???? | cave vulture | Exterior & Interior | 7 | 07-15-2009 01:01 PM |
ecu tune eliminate CEL? | genki370z | Intake/Exhaust | 1 | 07-02-2009 08:29 PM |