wow, good updates since I last checked the thread. Not sure if I want to swap that stalk but looks cool.
|
|
LinkBack | Thread Tools | Display Modes |
03-20-2019, 04:16 PM | #197 (permalink) | |
Base Member
Join Date: Aug 2017
Location: Pittsburgh
Posts: 104
Drives: 15 Nissan 370Z Sport
Rep Power: 8 |
Quote:
It was expensive and kind of a pain. Although I really didn’t want to cut into my harness. It’s still a virgin and I learned from past experiences on a previous vehicle I modified. Plus it was killing me inside that all the wiring was right there. |
|
09-14-2019, 03:30 PM | #198 (permalink) |
A True Z Fanatic
Join Date: Nov 2009
Location: Western Maryland
Posts: 1,280
Drives: Wife crazy & 09 370Z
Rep Power: 105454 |
So after many years I'm finally getting around to installing the fog light and just when I think I'm almost finished, something comes up that I just can't figure out.
I'm using the harness from the Z Store and I purchased the iJDMToy 3 in 1 fog lamp: fog lamp, reverse light and brake light. I wired the harness and switch in, ran all the lines to the trunk, tied the ground and power wire in to the same lines on the fog lamp. The switch works great. It turns the fog lamp on and off with no issues. I then spliced the reverse lamp in to the reverse light harness and this is where it gets weird. The reverse light won't come on unless I turn on the fog lamp via the switch. They are supposed to work independently of one another, but they aren't. If I disconnect the fog lamp leads from the switch harness and ground the lamp in the trunk, the reverse light comes on when the car is shifted in to reverse. Its as if the switch is controlling power for the entire lamp assembly, even though it has separate power leads for each light. Anyone have any suggestions on this?
__________________
~Rob -DD Air Guide, Stillen G3 CAIs, 63mm Throttle Bodies, Motordyne M370, Berk HFCs, FI TDX CBE (non-res, CF), Sprint booster v3, Ecutek Dyno Tuned, and the list goes on... Last edited by Spartan 1771; 09-14-2019 at 03:36 PM. |
09-14-2019, 04:11 PM | #199 (permalink) |
A True Z Fanatic
Join Date: Nov 2009
Location: Western Maryland
Posts: 1,280
Drives: Wife crazy & 09 370Z
Rep Power: 105454 |
One other thing I forgot to mention. The light on the switch is always illuminated, even if the fog light is switched off. Is this normal?
__________________
~Rob -DD Air Guide, Stillen G3 CAIs, 63mm Throttle Bodies, Motordyne M370, Berk HFCs, FI TDX CBE (non-res, CF), Sprint booster v3, Ecutek Dyno Tuned, and the list goes on... |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rear Fog Light Install? | Robert_Nash | Exterior & Interior | 27 | 06-25-2015 12:47 PM |
DIY: Blinder installation and radar detector hardwire | semtex | DIY Section (Do-It-Yourself) | 65 | 07-29-2012 08:49 PM |
Question about the Euro Spec. rear "Fog Light" | Arizona Z | Exterior & Interior | 7 | 03-26-2010 09:01 AM |
Request: DIY Radar Detector Hardwire w/out Power Rear View Mirrors | Viera | DIY Section (Do-It-Yourself) | 2 | 06-13-2009 10:53 PM |
Hardwire Radar Detector | zero610 | Audio & Video | 7 | 03-04-2009 08:52 PM |