Aftermarket shift knob gap fix.
 

So i bought a Mugen cf long shift knob and it had approx 1.25" gap from the base to the bottom of new knob.


This is an easy fixer uo to solve that problem. Very cheap and very light.
What you need:

1) Molding clay.( i used crayola air dry. Worked perfect and easy to mold.)
2) Aftermarket knob(obvious lol)
3) drill with proper diameter drill bit(varies in size needed)
4) stock shift knob.
5) sand paper
6) paint of your choice.

http://www.the370z.com/attachment.ph...1&d=1459003109
http://www.the370z.com/attachment.ph...1&d=1459003080

Step 1:

Take a small piece of clay are roll it smooth into somewhat shape and length
http://www.the370z.com/attachment.ph...1&d=1459003285
http://www.the370z.com/attachment.ph...1&d=1459003308

Step 2:

Form the ends in the same diameter of the base knob and new one.
http://www.the370z.com/attachment.ph...1&d=1459003461
http://www.the370z.com/attachment.ph...1&d=1459003515

Step4:

I made a ring so its recessed into the mold 1/8". Basically i simply pressed the new knob gently into the mold once i had the right diameter.
But not necessary.
http://www.the370z.com/attachment.ph...1&d=1459003717

Let stand for 3 hours and then drill out the proper size so it slips over the new adapter for the new shift knob.

Step 5:

Test fit. If it slides over the new adapter? Its ready for sanding and paint. I went some old 40th paint I had sitting around.
http://www.the370z.com/attachment.ph...1&d=1459004010
http://www.the370z.com/attachment.ph...1&d=1459004039

Final look.
Obviously the more time you take the better it will turn out.
Im not sure if i like the 40th. Probably going to repaint black.
http://www.the370z.com/attachment.ph...1&d=1459004246
http://www.the370z.com/attachment.ph...1&d=1459004300