DIY - Nav System Conversion

scope22 · 01-22-2016, 05:26 PM

Yea, ok i fixed it and it works great, i wired it wrong because instructions said pin 6 and 7 but they were missing so i thought that it maybe you meant 10 and 11...should have asked

Quote:

Originally Posted by VABAM

Based off your pic, you wired it in wrong. For starters the control signal wires that go to pins 6 and 7 require you to add pins to connector M66. Hopefully you didn't fry anything considering you wired the control wires (pins 4 and 5 of M67) to pins 10 and 11 of M66. Pin 10 is "LAN Signal" and pin 11 is "Each Motor Door Power Supply".

Why did you wire in to 10 and 11 instead of 6 and 7?

VABAM · 01-24-2016, 10:05 AM

Quote:

Originally Posted by scope22

Yea, ok i fixed it and it works great, i wired it wrong because instructions said pin 6 and 7 but they were missing so i thought that it maybe you meant 10 and 11...should have asked

I did mention in my disclaimer that you needed to add pins to a connector. Also I included the pin outs and wire diagram so you could check where to wire in yourself.

scope22 · 01-24-2016, 09:59 PM

Yea, i'm sure you did, i'm just special like that

Quote:

Originally Posted by VABAM

I did mention in my disclaimer that you needed to add pins to a connector. Also I included the pin outs and wire diagram so you could check where to wire in yourself.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
E-85 conversion	Elmo370z	Engine & Drivetrain	8	05-16-2015 07:40 PM
FLAT 6 conversion ???	PEPI	Nissan 370Z General Discussions	29	04-12-2014 05:24 PM
Z33.4 conversion anyone?	enkei2k	Nissan 370Z General Discussions	13	06-08-2012 07:33 PM
OEM Base Audio System to Full Bose System Swap / Conversion?	TopGone	Audio & Video	5	02-15-2011 11:34 PM
bhp to whp conversion	Canadian370Z	Nissan 370Z General Discussions	20	05-10-2009 12:13 AM