QuickJack Lift System

flyfish · 04-01-2019, 08:26 PM

Quote:

Originally Posted by bunk View Post
Well, when I first lifted the Z, on the first set of stops, I let the safety arms go over them, made sure that the release cams were in the up position so that it doesnt cause the bar to go over the stop. As I was lowering the QJ to engage the safety stops, one side popped over the safety stop, it literally popped, scared the crap out of me. Tried again, same thing. So as of now, if I need to use it on the lower setting, I just lower it so that the bars just touch the safety stops.

When its in the high position, its fine. But it still kinda makes me iffy, hence the jackstand backup. I had a friend in HS who was crushed working on his van a few weeks after graduating.

Quote:

Dude F that noise, you need to contact the manufacturer. I put jackstands underneath as well, but I only have two SUV-sized ones so those go on the end that I'm working under.

Agreed, you need to contact QJ for a solution, this is unacceptable. I do not have this problem, nor should you or anyone with this jack.

Which model do you have, I have the 7000SLX

.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
KW HLS (Hydraulic Lift System)	CLOUD10	Brakes & Suspension	45	02-09-2017 10:18 AM
Too low to lift car	laricb	Brakes & Suspension	18	01-07-2012 03:12 PM
Garage Lift System	maxtodorov	Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs	9	06-05-2010 06:26 PM