|
Finished the first side this morning with no issues. Yahoo! The service manual says to torque the front lower shock absorber bolts with the tires on the ground in the
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
12-06-2014, 11:26 AM
|
#7 (permalink) |
|
Enthusiast Member
 
Join Date: May 2014
Location: Houston, TX, USA
Posts: 280
Drives: 2014 370z Nismo
Rep Power: 11  |
Rear Springs and Arms
Finished the first side this morning with no issues. Yahoo! The service manual says to torque the front lower shock absorber bolts with the tires on the ground in the uladen position. As low as this car is I'm not sure that's realistic without an appropriate lift.
IMG_0737.JPG IMG_0738.JPG IMG_0736.JPG Also removed the other front shock/spring. Took ten minutes. Go figure. I decided to take them to the local Nissan dealer five minutes from my house. If anyone is set up to do it properly I have to assume they are. IMG_0734.JPG And found a screw in my tire IMG_0735.JPG
__________________
2014 370Z NISMO -- HKS Hi-Power Exhaust -- Swift Springs -- BC ER Coilovers -- SPL Suspension Components -- Nismo R-Tune Intake -- Seibon BD CF Hood Last edited by sandersd; 12-06-2014 at 11:31 AM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems with swift lowering spring install | Pnoyz916 | Brakes & Suspension | 60 | 04-01-2014 12:55 AM |
| Swift Spring install question | fl350z | Brakes & Suspension | 25 | 09-29-2013 12:20 PM |
| here are my alignment specs after swift spring install | area3z | Brakes & Suspension | 5 | 03-28-2012 07:24 AM |
| issues after swift install | alejo | Brakes & Suspension | 9 | 12-12-2011 10:40 AM |
7Likes
Threaded Mode
