Sway bar question, stock suspension...

Rusty

If not adjusted right. You could preload one side of the car more then the other side.

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

kenchan

that's wat i thought too, but i learned early on in my G that the improved posture will help turn-in and overall stability through the turn. but then there is a threshold. once you pass that threshold its like riding the bumpstops and understeer is very evident. lol

i run only front aftermarket swaybar on my Z. rear is stock.

cv129

Big bar up front, just like the discussion below

Jrz rs pro for track

synolimit

Well its sitting even left to right and the bar can sit even when swung up to the end links, zero tension. Personally I'd see no use of an endlink unless I wanted to raise or drop the height of the ends of the bar which would raise or lower where the front of the bar sits. To me I don't see how that'd do anything.

I did install the bar both ways. Once on one side then flipped upside down. The first pic I believe the bar is installed upside down. The ends at the links are very high and the front part of the bar is sitting high also up past the oil pan. The second and third pic the bars flipped. The ends at the links are lower and the front of the bar now sit even with the oil pan.

__________________
13 370z-

critical

what size for the front? i'm at 35mm. it felt a little funny with just the front bar on, but i didn't drive for more than a few miles to really get a grasp of it.

__________________
Quaife w/ gears |Stillen Gen 3|SOLD FI Resonated Test Pipes |SOLD FI 18'' | 25row Stillen Race | Progress 35mm/25mm sways | Swifts/Koni|Volk G25's| Stoptech SS lines||SPL Front/Rear Arms|

kenchan

mine's a small 27mm on soft setting. (36% stiffer than stock)

that's all the stock suspension needs, imo. my front wheel is 19x9 ET33.

synolimit

Whiteline?

__________________
13 370z-