Pics of drilled hole for KW V3 Rebound??? Anyone have any?
 

Does anyone have a pic of the hole they drilled in the back plastics to adjust the rebound on their KW V3's?

I don't want to start drilling in the wrong spot... Also, I'm too lazy at this point to take apart all of my plastics just to get a good look at it.

Any pictures would be greatly appreciated.

-Mike

Here is my setup but it isn't KW.
http://www.the370z.com/members/dr_-a...c-adjuster.jpg

where can I buy the knob I plan to do the same setup for my KW V3 meaning a permit one on each strut head.

I'm very interested and need to do this myself...

But I don't think the KWv3's have extended knobs like these?? :(

Correct me if I'm wrong please..

I know stance makes extensions for their setup. Guessing others do as well. If not, it wouldnt surprise me if theirs could be used on other setups.

I'm not sure about the KW, but here are my BC's

http://img.photobucket.com/albums/v2...023_210342.jpg

http://img.photobucket.com/albums/v2...023_210518.jpg

I trimmed mine down so the knob is a little more flush to the plastic

The KW uses a small allen wrench to adjust the topside, I forgot which size.

I'm sure you can go buy a cheapo allen wrench, glue it to a knob, and stick it in the adjuster. Possibly use some glue to hold it to the adjuster as well. Unless anyone knows a more professional method. ^^

For those that did this with any coil set, how do you measure out the right spot to drill through? A hole say 1" to put an allen wrench through to adjust so I don't have to remove my interior trim each time I need to adjust it...