Urgent: SPC REAR Camber arms won't fit?
 

SPC Rear Camber Arms HELP!

Took everything out, the bushings on the stock is tad bit wide. SPC camber arm bushing is too small and wont fit over...

Is there a special way to install this???

take a picture.

my camber arms were a bit different sized @ the bushing. I just had to tighten them down so that the bracket/frame whatever you want to call it bent in a little.

on my 350, which has the same setup and even uses the same arms, the bracket was a little tight and i had to bend it out a bit.

I'm an idiot....
I was looking at traction arm.

ALL GOOD!

Camber arms and coils installed :)

I'll post pics after alignment is done!