Swift springs review!!!!!

Alchemy · 08-15-2011, 01:53 PM

Quote:

Originally Posted by KingZee

If you haven't realigned it might be really negative or out of whack.

These springs are creaking like crazy, is this just normal during the settling phase or are they just noisy springs? The rubbers from OEM were properly installed.

I have never heard my springs make ANY noise, break in period or otherwise. I have heard others complaining though it usually turns out to be the rubbers. Not sure what it could be...

slumpey · 08-15-2011, 04:30 PM

How much does it cost to have the the swift springs installed? Are spacers necessary?

KamiSpeed · 08-15-2011, 04:53 PM

Quote:

Originally Posted by slumpey

How much does it cost to have the the swift springs installed? Are spacers necessary?

spacers aren't necessary, they're basically up to you

oleg · 08-16-2011, 02:01 AM

How is understear with these, im sure some one mentioned it already but there is no way im going through 56 pages. Why im asking because today i was doing some spirited driving and almost ended up in a parked mini cooper because of the understear i got going through a corner at 30mph.

christian370z · 08-16-2011, 02:40 AM

Quote:

Originally Posted by KingZee

If you haven't realigned it might be really negative or out of whack.

These springs are creaking like crazy, is this just normal during the settling phase or are they just noisy springs? The rubbers from OEM were properly installed.

They should not creak at all if they were in fact installed correctly, the only culprit is the OEM rubber mounts so I would look over them again.

Quote:

Originally Posted by slumpey

How much does it cost to have the the swift springs installed? Are spacers necessary?

I had mine installed for $225 at SpecialtyZ in California, but Seb has some of the best prices for labor and parts out there so that may be on the low side compared to other shops.

Quote:

Originally Posted by oleg

How is understear with these, im sure some one mentioned it already but there is no way im going through 56 pages. Why im asking because today i was doing some spirited driving and almost ended up in a parked mini cooper because of the understear i got going through a corner at 30mph.

The Swift springs give the car a much more neutral feel, removing most of the understeer that the stock springs had. Combined with a good set of sway bars, you can get rid of understeer completely. I have zero understeer with my Stillen sway bars and Swifts, just perfectly neutral balance through turns.

KingZee · 08-16-2011, 02:52 AM

Quote:

Originally Posted by christian370z

They should not creak at all if they were in fact installed correctly, the only culprit is the OEM rubber mounts so I would look over them again.

Thanks, I'll look it over but I saw the guys at Amp put them on...I'm not really getting creaking during normal driving, just when I'm trying to go up steep driveways sideways and they're really compressing and expanding...I may take them to extremes others wouldn't experience to get into my building's driveway without scrapping.

Quote:

The Swift springs give the car a much more neutral feel, removing most of the understeer that the stock springs had. Combined with a good set of sway bars, you can get rid of understeer completely. I have zero understeer with my Stillen sway bars and Swifts, just perfectly neutral balance through turns.

ggiwin · 08-16-2011, 04:25 AM

SWIFTS ARE AWESOME. Got them installed today and wow such a great improvement over the stock springs.

JJ-NISMO · 08-27-2011, 03:06 PM

Quote:

Originally Posted by ggiwin

SWIFTS ARE AWESOME. Got them installed today and wow such a great improvement over the stock springs.

If you have creaking issues, it is because the OEM rubber rings were not put on the Swifts correctly. I had creaking issues, went back and put the rubber rings on, and have not had any issues since. Check my post in the review and the Nismo Swift review if you want pics.

fuct · 08-27-2011, 04:18 PM

Quote:

Originally Posted by oleg

How is understear with these, im sure some one mentioned it already but there is no way im going through 56 pages. Why im asking because today i was doing some spirited driving and almost ended up in a parked mini cooper because of the understear i got going through a corner at 30mph.

theres too many other factors for you to pin point the springs causing it.

ggiwin · 08-27-2011, 04:29 PM

unfortunately, I could not get back to factory specs. Have to order a camber kit for the rear. Fr -1.5 both sides, Rr -2.5 and -2.4 was the best they could get it to. Toe and caster were good all around.

Alchemy · 08-27-2011, 05:01 PM

I got 1.5 front and 2.2, 2.0 rear. Left it as is, feels pretty darn good.

ggiwin · 08-27-2011, 05:13 PM

Anyone know if running -2.5 rears will destroy my tires?

fuct · 08-27-2011, 05:42 PM

Quote:

Originally Posted by ggiwin

Anyone know if running -2.5 rears will destroy my tires?

wont ruin, but will wear them out fast

at -2 degrees my back tires lasted 15k miles. and that was babying them. (15k miles isnt bad on a car like this though)

since you cant adjust front camber i wouldnt wory about -1.5

ggiwin · 08-27-2011, 05:46 PM

spc rear camber kit it is then

thanks

Red__Zed · 08-27-2011, 06:07 PM

Quote:

Originally Posted by ggiwin

Anyone know if running -2.5 rears will destroy my tires?

no. I put 6k on my rears at 2.5/2.6 and they wore perfectly evenly.

08-15-2011, 04:30 PM	#827 (permalink)
slumpey Base Member Join Date: May 2011 Location: USA Posts: 80 Drives: 2011 Nissan 370Z 7AT Rep Power: 14	How much does it cost to have the the swift springs installed? Are spacers necessary? Last edited by slumpey; 08-15-2011 at 04:38 PM.

08-27-2011, 05:01 PM	#836 (permalink)
Alchemy A True Z Fanatic Join Date: Jan 2009 Location: Jersey Age: 44 Posts: 4,855 Drives: to acquire tickets Rep Power: 3524	I got 1.5 front and 2.2, 2.0 rear. Left it as is, feels pretty darn good. __________________ Ryan 314WHP \| 260LB-FT \| STILLEN \| KONI \| SWIFT \| STOPTECH \| Z1 \| PROJECT MU \| CNT \| UPREV \| FORGESTAR \| BRIDGESTONE \| PWJDM \| ENEOS \| MOTUL

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Swift Springs-- Nismo Review!!	JJ-NISMO	Brakes & Suspension	39	07-29-2014 08:59 AM
[WTB] Swift Springs	Beastmode	Parts for sale (Private Classifieds)	1	09-13-2011 05:46 PM
BC ERs with Swift Springs and RA Valving REVIEW / (Picture Heavy)	Mozen	Brakes & Suspension	31	05-24-2011 11:46 AM
WTB: Swift or H&R Springs	Mr&Mrs	Wanted	5	04-26-2011 11:51 PM
Swift Springs	Justin1686	North East Region	10	02-24-2011 07:58 PM

08-16-2011, 02:01 AM	#829 (permalink)
oleg Enthusiast Member Join Date: Dec 2010 Location: Illinois Posts: 321 Drives: 2011 370z 6mt sp Rep Power: 14	How is understear with these, im sure some one mentioned it already but there is no way im going through 56 pages. Why im asking because today i was doing some spirited driving and almost ended up in a parked mini cooper because of the understear i got going through a corner at 30mph.

08-16-2011, 04:25 AM	#832 (permalink)
ggiwin Base Member Join Date: Jun 2010 Location: orange county Posts: 226 Drives: 2010 AT PW Rep Power: 15	SWIFTS ARE AWESOME. Got them installed today and wow such a great improvement over the stock springs.

08-27-2011, 04:29 PM	#835 (permalink)
ggiwin Base Member Join Date: Jun 2010 Location: orange county Posts: 226 Drives: 2010 AT PW Rep Power: 15	unfortunately, I could not get back to factory specs. Have to order a camber kit for the rear. Fr -1.5 both sides, Rr -2.5 and -2.4 was the best they could get it to. Toe and caster were good all around.

08-27-2011, 05:13 PM	#837 (permalink)
ggiwin Base Member Join Date: Jun 2010 Location: orange county Posts: 226 Drives: 2010 AT PW Rep Power: 15	Anyone know if running -2.5 rears will destroy my tires?

08-27-2011, 05:46 PM	#839 (permalink)
ggiwin Base Member Join Date: Jun 2010 Location: orange county Posts: 226 Drives: 2010 AT PW Rep Power: 15	spc rear camber kit it is then thanks