Front Subframe Replacement
 

do I have to remove the engine and transmission to change the front subframe .

The very first step according to the FSM is "remove engine and transmission assembly". I'd imagine you have to remove the transmission but it might be possible to support the engine from the top while you disconnect the subframe member - other smarter people will know the answer to this. Dropping the whole cradle and lifting the car off it is the easiest method of removing the engine tho; and then you can disconnect the subframe with it out of the vehicle.

It this were me using a lift or even on the ground I'd use chains or straps and put them under the motor mount arms and go over the strut bar to hold the engine up. Use rags under the chains so you don't scuff up the strut bar. I would also put a block of wood or a single post under the bell housing to hold the weight of the trans and engine. Then just start un bolting things like the lower control arms, outer tie rods etc etc. I would definitely have someone help you especially if you're going to be doing the job on your back. I would have to be under my Z right night to give you more information but I'm nice and toasty in my blankie having a Guinness. Let me know if I can be of more assistance.

And how the hell did that happen?

Dukes of Hazzard, What else..... :roflpuke2:

How'd you manage to get the car upside down?

You've got additional problems over just the subframe. The oil pan is toast. :owned:

Did ya do this?

Maybe it was this.

I think I speak for all of us here when I say what the **** did you hit?

Or who...

Never use a Z to 80-6 someone. See what happens.

Philadelphia pot holes smh

Yea trying to fix it all in one shot

Crazy pot hole