Torque specs for Caliper halves bolts

Rusty

When I worked at Elliott TurboMinchinery. On some applications, we measured bolt/stud stretch. On others. We installed the nuts hand tight. Then heated up the bolt/stud up. Then turned the nut so many flats to set the torque. We also used a HydroTorque wrench. Which is a hydraulic wrench. You set the torque by how much hydraulic pressure you have at the head.

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

g96818

Hope they do. Told them i was planning on powder coating their uncoated caliper and need to disassemble the calipers so we'll see.

__________________
CZP are lying thieves!

g96818

I know this thread is really old, but I have the definitive torques straight from Akebono USA.


Front Caliper 17mm bolts: 69.2 - 93.6 Newton meters (51 - 69 ft-lbs)
Rear Caliper 14mm bolts: 32.0 - 43.3 Newton meters (24 - 32 ft-lbs)


This falls in-line with what I previously measured.

__________________
CZP are lying thieves!