Help with Coilover install!!!

krishdes · 02-28-2016, 02:10 AM

So, I was installing my coilovers I recently got and after finishing the front moved to the back of the car. Now, for just basic info on my car, it is a base coupe 2013 370z with 16,000 miles on it. So, went to remove the rear driver side oem shock and the rubber bushing was spinning with the bolt... what do I do? I searched this forum and this problem wasn't really common, but was very common on the 350z.

RadioFlyer · 02-28-2016, 10:09 AM

Clean the threads with a wire brush, spray tons of lube on it, and hit it with an impact.

Rusty · 02-28-2016, 01:42 PM

You got to spray lube between the bolt and the bushing. Then use a long screw driver or pry bar on the end of the bolt to push it out, while using an impact or wrench to turn the bolt.

02-28-2016, 01:42 PM	#3 (permalink)
Rusty Ronin Samurai - Assassin Join Date: Dec 2011 Location: Fayettenam,Pennsyltucky Age: 68 Posts: 35,217 Drives: 2011 Nismo GM 6M Rep Power: 2684438	You got to spray lube between the bolt and the bushing. Then use a long screw driver or pry bar on the end of the bolt to push it out, while using an impact or wrench to turn the bolt. __________________ 浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
coilover install on maui	outkazt	Hawaii	2	12-12-2015 08:28 PM
BC BR coilover install	DeliriousClam	Brakes & Suspension	5	08-11-2015 01:34 PM
DIY: Coilover Install	destinyZ	DIY Section (Do-It-Yourself)	24	08-05-2014 01:17 AM
DIY coilover install	azn370z	DIY Section (Do-It-Yourself)	31	08-05-2014 01:11 AM
install new coilover question	cossie1600	Brakes & Suspension	4	12-12-2013 08:08 AM

02-28-2016, 10:09 AM	#2 (permalink)
RadioFlyer Base Member Join Date: Aug 2014 Location: Los Angeles, CA. Posts: 193 Drives: 08 G37S S/C Rep Power: 40	Clean the threads with a wire brush, spray tons of lube on it, and hit it with an impact.