|
I have 2010 z with swift springs and recently went from stock 18s to rohana rc10s 20's. Went directly through Rohana and they knew the offset that would sit flush.
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
06-08-2016, 09:55 PM
|
#1 (permalink) |
|
Base Member
Join Date: Oct 2014
Location: hudson county nj
Posts: 53
Drives: 2010 370z
Rep Power: 11  |
Camber issue after wheel install
I have 2010 z with swift springs and recently went from stock 18s to rohana rc10s 20's. Went directly through Rohana and they knew the offset that would sit flush. Not sure off the top of my head what it is. The fronts look great and after the rears were installed i noticed the tops are tucking in. I went for alignment hoping this would pull it back out and have them sit right but they had no luck. I attached the specs from the alignment. They recommended getting a rear camber kit. I am going to probably order SPC rear camber adjustable arms. Will this do the job or is there something else I should be looking for?
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OE Camber Issue, Parts Advice Needed Please | Tractionless | Brakes & Suspension | 4 | 02-07-2016 09:09 AM |
| Possible Camber issue after accident. Halp! | aworst001 | Brakes & Suspension | 4 | 09-25-2015 11:47 AM |
| For those with SPC Camber kit install | Hatsuongmai | Brakes & Suspension | 7 | 10-07-2013 07:18 PM |
| Typhoon K&N Install issue | Ridgerunner | Intake/Exhaust | 2 | 10-13-2010 11:29 PM |
| Interesting Issue after an install | Mrabyss | Audio & Video | 10 | 04-15-2009 12:34 PM |
8Likes
Threaded Mode
