VDC Off light on/ Skid Light on and Break Light on
 

Had my rotors and break pads switched out for a new set, these 3 lights are coming on. I have seen some posts that the fluid level being low can cause this....Any suggestions??

If it's not the level (it has to be FULL), check the wheel speed sensors. More info, diagnostics, &c in the FSM.

Same thing happened to me after a tire balance:icon14:
Brake Fluid level MAX and ConsultII listed the drivers front speed sensor as the culprit so I bought a new one and changed it out.... Lights Still On:icon14:

Break light !!!!!

http://comps.canstockphoto.com/can-s...sp17125382.jpg

Serious replies please, this sh1t is annoying:ughdance:

Did you clear the DTC? If you cleared the DTC and it keeps popping back up, I'd check the wiring. More info in the FSM, including R&R procedures (verify you did it right) and wiring diagrams.

:eek: Welcome to the Intertubes and learn to laugh at yourself when you make spelling errors. :driving: Complaining about it usually just makes it worse.

Check brake fluid level

I had my mechanic use the Consult II or III (cant remember) to read the code and it came up Fr drivers side wheel speed sensor so I replaced that but the 3 lights remain. They come on when I start the car in the morning and Immediately turn off when I start driving. After about 1/4 mile of driving the come back on and stay on until I cut the car off and start driving again. I will have him reset the code again but Im certain after 3-5mins of driving they will come back on:shakes head:

Hey that annoying sh*t was a free bump for your thread! :icon23:

Top off your brake fluid. Bring it up past the full line.

Already did this before the problem



not even my thread but the same problem:rofl2: