![]() |
Word of advice when doing these in cold weather. Clean the surface with rubbing alcohol as best you can. Try to avoid using goo gone if you can because unless
|
|
LinkBack | Thread Tools | Display Modes |
![]() |
#11 (permalink) |
A True Z Fanatic
Join Date: Feb 2011
Location: Maryland
Posts: 5,930
Drives: AWD TT 370z
Rep Power: 27 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
Word of advice when doing these in cold weather. Clean the surface with rubbing alcohol as best you can. Try to avoid using goo gone if you can because unless you get it ALL off, it will ruin the 3M backing.
Once the area is clean, carefully affix the new emblem and strap down both "sides" of the emblem securely with blue heat-resistant painter's tape. You do this because the back of the emblem is flat, whereas the area on your hood where you're attaching the badge is slightly convex. If you don't strap down both sides of the emblem, you may end up with one side sitting "higher" in the recession than the other. Then cover the whole badge with tape and hit it in short bursts with the heat gun on LOW. Leave the tape on the car for 2-3 days, then remove. Voila, permanent emblems.
__________________
![]() Last edited by dmhenderson; 09-27-2012 at 10:39 AM. |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Replacement Front & Rear "Z" Emblem | JDUKUSA | Exterior & Interior | 3 | 04-17-2012 11:30 PM |
[FOR SALE] Gloss Black Door Handles, Nissan Emblems, and "Z" Sidemarkers | Stanced370Z | Parts for sale (Private Classifieds) | 18 | 08-25-2011 05:49 AM |
WTB: front and rear carbon fiber "Z" emblem | Calvin | Wanted | 0 | 02-06-2010 06:01 PM |
"Warning" Carbon Fiber Z emblems "DO NOT FIT" | NXTAZEE | Exterior & Interior | 2 | 12-20-2009 03:49 AM |
370Z Factory "Fairlady Z" Emblems in stock, At the 350ZSOURCE!!! | Michael@TheZStore | Exterior & Interior | 13 | 08-01-2009 11:59 AM |