Engine Noise :(

bigaudiofanat · 11-03-2009, 12:20 PM

Yes that is what I am saying right to the metal. For your amp ground wire I know it is probably fine were it is but it could be picking up noise there and I was saying if need be you can make it longer. Before you do any of this do the ipod test and see what you find out. No problem man.

jrniehaus · 11-04-2009, 07:17 PM

ok, so I rerouted remote-on lead. and grounded deck to shifter bolt area. buzz is still there but very little. But, I didn't sand down the paint to that area. I should have done that, but didn't due to the tight area. I will try that next time i have a chance. BUT, now I noticed a new issue. Not sure if I disconnected something or if something is wrong now, because the steering wheel volume swithc is no longer working. The source button and can change the channels with the other controls, it is simply the volume that isn't working. Now, I may have pushed the button too hard and it may be the switch. Or, it is the control adaptor that was hooked to my HU. I am not sure if it could be the hook up to the HU or if it is a faulty switch due to the fact that I may have pushed it too hard. Any ideas? If it is the button, maybe I can take it out and make sure I didn't break something by pushing it too hard. I can easily replace that, but I never took one of those out of the steering wheel.

11-03-2009, 12:20 PM	#1 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	Yes that is what I am saying right to the metal. For your amp ground wire I know it is probably fine were it is but it could be picking up noise there and I was saying if need be you can make it longer. Before you do any of this do the ipod test and see what you find out. No problem man. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
1st gear noise	rench	Engine & Drivetrain	105	12-21-2012 10:48 PM
Rear End Noise	bradz	Nissan 370Z General Discussions	18	06-23-2011 05:04 PM
Noise issues	nuts4nissan09	New 370Z Owner	5	08-27-2009 12:46 PM
G37 engine and 370z engine	kannibul	Nissan 370Z General Discussions	21	08-12-2009 01:58 AM
Tire Noise	dwhitley0381	Nissan 370Z General Discussions	0	06-11-2009 09:34 AM

11-04-2009, 07:17 PM	#2 (permalink)
jrniehaus Base Member Join Date: Oct 2009 Location: Phx,AZ Posts: 45 Drives: 370z 6spd sport mdl Rep Power: 16	ok, so I rerouted remote-on lead. and grounded deck to shifter bolt area. buzz is still there but very little. But, I didn't sand down the paint to that area. I should have done that, but didn't due to the tight area. I will try that next time i have a chance. BUT, now I noticed a new issue. Not sure if I disconnected something or if something is wrong now, because the steering wheel volume swithc is no longer working. The source button and can change the channels with the other controls, it is simply the volume that isn't working. Now, I may have pushed the button too hard and it may be the switch. Or, it is the control adaptor that was hooked to my HU. I am not sure if it could be the hook up to the HU or if it is a faulty switch due to the fact that I may have pushed it too hard. Any ideas? If it is the button, maybe I can take it out and make sure I didn't break something by pushing it too hard. I can easily replace that, but I never took one of those out of the steering wheel.