Engine Noise :(

SlikNik · 11-02-2009, 05:38 PM

I have the same amp and just finished my install last week. No engine noise luckily.
I ran rca's down the middle, power wire down the drivers side. New speaker wire from amp(under that black foam piece) to crossovers under the seats, to door components. When your wires start to get closer together as they get closer to the amp make sure they don't run parallel next to each other. If they have to cross each other I have always heard to cross them at 90 degrees. I used that bolt to the left of the remote sensor thingy that was talked about in another thread to ground my amp. Used a wire brush in a drill to clean it down to metal.
The head unit is grounded to the wire harness on mine.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
1st gear noise	rench	Engine & Drivetrain	105	12-21-2012 10:48 PM
Rear End Noise	bradz	Nissan 370Z General Discussions	18	06-23-2011 05:04 PM
Noise issues	nuts4nissan09	New 370Z Owner	5	08-27-2009 12:46 PM
G37 engine and 370z engine	kannibul	Nissan 370Z General Discussions	21	08-12-2009 01:58 AM
Tire Noise	dwhitley0381	Nissan 370Z General Discussions	0	06-11-2009 09:34 AM

11-02-2009, 05:38 PM	#25 (permalink)
SlikNik Enthusiast Member Join Date: May 2009 Location: Florida Posts: 294 Drives: 2015 Corvette Z51 Rep Power: 18	I have the same amp and just finished my install last week. No engine noise luckily. I ran rca's down the middle, power wire down the drivers side. New speaker wire from amp(under that black foam piece) to crossovers under the seats, to door components. When your wires start to get closer together as they get closer to the amp make sure they don't run parallel next to each other. If they have to cross each other I have always heard to cross them at 90 degrees. I used that bolt to the left of the remote sensor thingy that was talked about in another thread to ground my amp. Used a wire brush in a drill to clean it down to metal. The head unit is grounded to the wire harness on mine.