Worked for me too. Sweet. Thanks!! ;)

So, I've tried this fix about 600 times in 60 different ways over the last 6 months and haven't had any luck. The manual mode still works, but the automatic mode and the door close/window raise mode don't work. Also, it won't go up while the door is open, but it will go down.

This happened after I replaced the speakers and pulled the door panel to put in sound proofing. This is on the driver's side only and I'm about ready to go buy a replacement switch at $100, but am reaching out in hopes that somebody might have another suggestion to try.

Thanks!

So as an FYI - It was recommended to disconnect the battery during install. That will help avoid most of the issues. But it was noted that if you disconnect it to often that you will still get a SES light. That code is P0603. Should be able to be cleared with any code reader.

I have a question.. I installed an aftermarket stereo.. Works fine but the radio picks up some interference. My guess is because I did not ground it (couldn't find where to ground it).. Is this why? Where can I ground it?

Hey guys. 2010 Nismo with base radio. I'm switching out to a Pioneer HU, what is the white box/module that sits directly under the stock hu? It has to be unplugged (big plug) and comes out with the stock radio. I'm just wondering if it was to be reinstalled with the new unit still. Thanks

Yes it does.

:tup:

Yeah IIRC that box is basically the climate control computer.

Good to know.

I recently installed 2 subwoofers in my 13 z, and now my a/c and windshield wipers don't work. Air comes out but doesn't gwt cold. Water for wipers comes out but wipers don't move. Checked fuses and they are fine. All of my connections are connected. Ant ideas why this could be and how to fix it? Both were working fine before install.