Alternate source for 12v power

vermithrax · 05-10-2012, 10:14 PM

so the blue and blue/white wires on the metra harness don't need to be connected to the head unit blue/white wire? Is the Blue/white wire on the head unit harness only to be hooked up to a REM amp wire?

If so, I will just use that, and worry about the powered woofer when I get it.

bigaudiofanat · 05-10-2012, 10:53 PM

Quote:

Originally Posted by vermithrax

so the blue and blue/white wires on the metra harness don't need to be connected to the head unit blue/white wire? Is the Blue/white wire on the head unit harness only to be hooked up to a REM amp wire?

If so, I will just use that, and worry about the powered woofer when I get it.

The blue wire on the metra as I said, only needs to be used if you have a factory amp "you do not" so yo can omit that wire and use the blue/white wire for your amp.

tibal · 09-17-2012, 04:38 PM

Figured this would be a good thread to run off of. Basically same question " I am looking for an alternate source for 12v power".

I am looking for a solid 12v constant to tap my CarPC into. I was going to run off my Pioneer HU existing 12v constant and switched, but think that I would be maxing out that line and may not be smart. I want a clean 12V constant source without having to tap right from battery.

Off hand, is the cigarette lighter a 12v constant source? Also, for the 12v switched, would it be okay to run off of the HU or would there be a better source for both?

bigaudiofanat · 09-17-2012, 06:24 PM

Quote:

Originally Posted by tibal

Figured this would be a good thread to run off of. Basically same question " I am looking for an alternate source for 12v power".

I am looking for a solid 12v constant to tap my CarPC into. I was going to run off my Pioneer HU existing 12v constant and switched, but think that I would be maxing out that line and may not be smart. I want a clean 12V constant source without having to tap right from battery.

Off hand, is the cigarette lighter a 12v constant source? Also, for the 12v switched, would it be okay to run off of the HU or would there be a better source for both?

The 12 volt power plug is one option. However if you need a clean and strong power source fuse and run a 14 gauge wire from your battery, and if you need a switched source setup a basic relay and a fused line from your battery.

tibal · 09-18-2012, 10:28 AM

Quote:

Originally Posted by bigaudiofanat

The 12 volt power plug is one option. However if you need a clean and strong power source fuse and run a 14 gauge wire from your battery, and if you need a switched source setup a basic relay and a fused line from your battery.

Hmm sounds like that may be the best option then. (running from the battery. I will have to look into options for that.

For the constant 12v w/ 14ga wire from battery- 10A inline fuse sufficient?
http://www.radioshack.com/product/in...tent=CT2032234

bigaudiofanat · 09-18-2012, 10:44 AM

Quote:

Originally Posted by tibal

Hmm sounds like that may be the best option then. (running from the battery. I will have to look into options for that.

For the constant 12v w/ 14ga wire from battery- 10A inline fuse sufficient?
http://www.radioshack.com/product/in...tent=CT2032234

Match your fuse to what your device needs.

tibal · 09-19-2012, 10:33 AM

Quote:

Originally Posted by bigaudiofanat

Match your fuse to what your device needs.

Oh gosh now were getting beyond my auto electronic knowledge.

Looking into it I think a 20amp inline fuse close to the battery may be sufficient.

My device is a CarPC running a Mini-Box M2 ATX 160w power Supply

Smart Car PC Power Supply
- 160 watts output
- Ideal car Power supply for operating Core 2 duo, Celeron, AMD systems
- ATX, 6-24V wide input range
- Intelligent shutdown controller
- ON/OFF motherboard control
- Survives vehicle engine cranks
- Battery deep discharge prevention
- High efficiency, 160 watts output
- "Anti-Thump" Amplifier remote control - 15A automotive fuse (mini-blade)
- VIA, P4 and AMD CPU support
- manufactured by mini-box.com
- ROHS compliant version

So in retrospect, I will be running 2 power wires, from the battery, one for constant and one for switched. On the switched I will use a relay.

bigaudiofanat · 09-19-2012, 12:48 PM

Quote:

Originally Posted by tibal

Oh gosh now were getting beyond my auto electronic knowledge.

Looking into it I think a 20amp inline fuse close to the battery may be sufficient.

My device is a CarPC running a Mini-Box M2 ATX 160w power Supply

Smart Car PC Power Supply
- 160 watts output
- Ideal car Power supply for operating Core 2 duo, Celeron, AMD systems
- ATX, 6-24V wide input range
- Intelligent shutdown controller
- ON/OFF motherboard control
- Survives vehicle engine cranks
- Battery deep discharge prevention
- High efficiency, 160 watts output
- "Anti-Thump" Amplifier remote control - 15A automotive fuse (mini-blade)
- VIA, P4 and AMD CPU support
- manufactured by mini-box.com
- ROHS compliant version

So in retrospect, I will be running 2 power wires, from the battery, one for constant and one for switched. On the switched I will use a relay.

Match the fuse rating on your power supply.

tibal · 09-19-2012, 04:52 PM

Quote:

Originally Posted by bigaudiofanat

Match the fuse rating on your power supply.

Yessir,

Going to pick up an inline 15amp fuse today and some 10-14 ga wire. Hopefully get this puppy wired in tonight and will document how it goes in a new thread. Thanks Big per usual.

09-17-2012, 04:38 PM	#18 (permalink)
tibal Track Member Join Date: Dec 2008 Location: Safest Town In America Posts: 987 Drives: TT-370Z and 2.5RS Rep Power: 17	Figured this would be a good thread to run off of. Basically same question " I am looking for an alternate source for 12v power". I am looking for a solid 12v constant to tap my CarPC into. I was going to run off my Pioneer HU existing 12v constant and switched, but think that I would be maxing out that line and may not be smart. I want a clean 12V constant source without having to tap right from battery. Off hand, is the cigarette lighter a 12v constant source? Also, for the 12v switched, would it be okay to run off of the HU or would there be a better source for both? __________________ 2010 - PG - M6 - 370zTT 453/409 6lbs IG @TRbal10 TEAM FLY1 MOTORSPORTS

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Alternate Method for GTR Red Start-Stop Button Swap	Zmax	DIY Section (Do-It-Yourself)	9	03-24-2012 10:26 AM
Source for LED lighting?	Pat C.	Exterior & Interior	13	03-24-2012 10:02 AM
Easiest source of switched power?	gr8-wrx	Exterior & Interior	2	04-12-2011 01:41 PM
video camera recorder needs a power source	zmyride	DIY Section (Do-It-Yourself)	1	03-16-2011 05:59 PM
Alternate tires for 225/50r18?	Ptrlsgt	Wheels & Tires	3	08-31-2010 10:56 PM

05-10-2012, 10:14 PM	#16 (permalink)
vermithrax Base Member Join Date: Apr 2012 Location: Houston Posts: 128 Drives: 11 370z/sport silver Rep Power: 13	so the blue and blue/white wires on the metra harness don't need to be connected to the head unit blue/white wire? Is the Blue/white wire on the head unit harness only to be hooked up to a REM amp wire? If so, I will just use that, and worry about the powered woofer when I get it.