rear panel tab / clips..
 

Hi,
While removing the rear panels I lost one of the V shaped white colored tab (male)...

is there a place I can get one? (will advanced auto have this?)

Thanks,

they might, but check with your dealer too.

Also, depending on the area you can use 3M doublesided mounting tape (just fold it over once to get the right thickness). i do that sometimes when one either breaks or lost.

I've got a whole bunch of extra parts at home. Let me check this evening and I'll send you a PM either way.

I bought all of the rear plastics from AM Performance so I may have the clip you're needing.

Thanks Ken.

Thanks Brian, i actually found the clip... in the trunk when I was in there doing more dynamat...

how can i get the center console off? I have it loose but the gear boot is in the way.. I dont get how to remove it... I have a MT;.. also for the center console where is the connection that I need to disconnect ?

Thanks,

I Dynamatted in one of my screwdrivers. :eek:

Everytime I pull out the center console, I forget how I did it the last time.
Make sure and pull the parking brake all the way up. You'll kind of have to work it back and forth to get it out. You might want to put a towel on the end closest to the HU to keep from scratching things.

Once you get the console out, you should be able to tell where the connection is. You'll see the wires running to the 12v outlet.

lol, atleast now you will always have a screwdriver no matter where you go...

So I can get the center console out without having to remove the boot around the shifter ?

Also do you how to get to the back of the license plate light? My camera goes in there but cant figure out how to get the wire to the trunk from there..

Also I think I had seen pic;s of your 9960 install where you used(?) the dash kit.. I had not till day, but now I am thinking of using it since I have it sitting around and hope to get rid of the extra space around the HU...

jayl - for the wiring to the bumper you can use the grommet on the driver side back wall and feed the wire through the bumper. i removed my driver side taillamp when i did the foglamp and camera install. :)

did you dynamat everything metal area ? sides (under the tail lights) / back of license plate etc.. where the rear speakers go...

Thanks Ken.

got it out thanks!.

Ditto.

I thought I was going to be brilliant and put my camera on the right side of the license plate, which I did, but scratched the living crap out of my arm doing it. There are some screws that face down that I took out to get separation to feed the camera/wire through. I could only do about 1/4 turn at a time. It looked like I'd been fighting a badger once I got done.

got it in the trunk..

That sounds dirty. :)

HI,
I ended up using the grommet that was closest to the right side license plate light... should I make a cut in it and pass the wire form it? or do I pass the wire under it and then close it back up?

thanks,

through it.