Rolex speaker connection

90 ST · 03-23-2011, 09:10 PM

i'm not sure i get the question, but you don't replace any connections, you have to use them, by feeding your wire through in the open spot.

37Z · 03-24-2011, 06:33 PM

Quote:

Originally Posted by 90 ST

i'm not sure i get the question, but you don't replace any connections, you have to use them, by feeding your wire through in the open spot.

That's my intuition as well; however, a local car audio dealer/installer mention a separate molex. Not sure if this is hype or just to speed up the install.

Juleous · 03-24-2011, 06:50 PM

Quote:

Originally Posted by 37Z

That's my intuition as well; however, a local car audio dealer/installer mention a separate molex. Not sure if this is hype or just to speed up the install.

Your talking about the Scosche adapters for your Head Unit to the Z factory radio harness. You need two one for your power, ignition etc, and one for the antenna. This allows you to connect your new head unit without having to cut up your factory wire harness. All your speakers will need new speaker wire as the factory wire is far too small, so then all factory molex speaker connectors will be just left unhooked.

90 ST · 03-24-2011, 07:40 PM

Quote:

Originally Posted by 37Z

That's my intuition as well; however, a local car audio dealer/installer mention a separate molex. Not sure if this is hype or just to speed up the install.

I c what you mean, yes as Juleous mentioned there is a harness you can use between the aftermarket HU and the stock wire for power ground, ect, but to get good wire from the amp to the speakers/X-over you will have to run new wire and go through the molex connector in the door as shown in the pics.

37Z · 03-25-2011, 03:25 PM

Quote:

Originally Posted by 90 ST

I c what you mean, yes as Juleous mentioned there is a harness you can use between the aftermarket HU and the stock wire for power ground, ect, but to get good wire from the amp to the speakers/X-over you will have to run new wire and go through the molex connector in the door as shown in the pics.

Is their a crossover for the stock non-bose speakers? If so, where is it located?

37Z · 03-26-2011, 05:40 PM

Quote:

Originally Posted by 37Z

Is their a crossover for the stock non-bose speakers? If so, where is it located?

Also, which is the best type of speaker wire connector to connect to the speaker (i.e spade, solder, etc.)?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2007 Cayman S 2010 370z Rolex Vs Seiko Vs Omega	sheps58	Nissan 370Z General Discussions	38	10-21-2010 12:14 AM
Rolex and NJMP	tooohip	Mid-Atlantic Region	3	07-01-2010 01:52 PM
About bluetooth connection	OhYeah	Nissan 370Z General Discussions	3	01-20-2010 09:29 PM
iPod connection to AV inputs	javol	Audio & Video	11	11-08-2009 07:19 PM
Missed Connection	Sashimi	Northern California Region	0	07-06-2009 03:27 AM

03-23-2011, 09:10 PM	#1 (permalink)
90 ST A True Z Fanatic Join Date: May 2010 Location: Calgary Posts: 1,861 Drives: 90 and 15 GMC Sierra Rep Power: 421	i'm not sure i get the question, but you don't replace any connections, you have to use them, by feeding your wire through in the open spot.