Help with My Install

LinPark

Ok, I've got all of the critical speaker/power wires done:

• Yellow to Yellow for 12V constant
• Red to Red for 12V accessory
• Black to Black for ground
• White to White for Front Left +
• White/Black to White/Black for Front Left -
• Gray to Gray for Front Right +
• Gray/Black to Gray/Black for Front Right -
• Orange/White to Orange/White for Dimmer Control

Excluding the rear speaker wires, that leaves the following on the DNX9960 harness:

• Brown for Mute
• Blue for Antenna Control
• Blue/White for Power Control
• LtBlue/Yellow for Steering Control - which goes to the Axxess

And just a blue antenna wire on the 70-7552 harness (well, mine seems to have an Orange/Black one sitting in pin 10 and I have no clue what that is for because its not mentioned in any of the documentation I can find). Any idea what those first 3 are that are left on the HU harness?

Ok, the reason I asked about the others is because I could use 3 of them to move into pins 6, 15, and 16 because these are the 3 that the steering controls use. I'm thinking of moving the wires from the rear speakers into those pins and then soldering the Axxess leads to those for a nice fit that doesn't cut into the factory wires behind the factory terminal.

Thanks for the tips on the unused wires!