Aftermarket Deck with Bose speakers

diablokev87 · 02-13-2011, 07:50 PM

Quote:

Originally Posted by JACKPAC

I'm a little confused, maybe because I don't have any wiring manuals in front of me right now. Above is what I'm planning on doing in a couple of weeks, but I'm confused about how all the wiring fits together. It's always been HU -> Scoche wireing harness -> factory wiring for any previous install I've ever done. But where does the Pac SOEM-4 fit into the mix? Does it connect between the HU and the Scoche, or between the scoche and the factory wiring? Thanks for the clarification.

Signal Wires from HU: HU -> PAC -> Scoche Harness -> Factory.
Other Wires from HU: HU ->Scoche Harness -> Factory

Also keep in mind, some wires from the PAC (like power and ground) will connect to the Scoche Harness.

chirowolf · 02-14-2011, 09:01 AM

Quote:

Originally Posted by diablokev87

Signal Wires from HU: HU -> PAC -> Scoche Harness -> Factory.
Other Wires from HU: HU ->Scoche Harness -> Factory

Also keep in mind, some wires from the PAC (like power and ground) will connect to the Scoche Harness.

Diablokev is correct. My biggest problem was getting everything to fit back into the dash.
I think someone in this thread said it was not important to have the PAC. I would have to disagree. When I originally had the pack installed I did not tune the PAC(line outs) adn sound became very distorted with alot of white noise in the back round. After I "tuned"the line outs the sound quality is great ( I think much better than factory )

diablokev87 · 02-14-2011, 09:58 AM

Quote:

Originally Posted by chirowolf

Diablokev is correct. My biggest problem was getting everything to fit back into the dash.
I think someone in this thread said it was not important to have the PAC. I would have to disagree. When I originally had the pack installed I did not tune the PAC(line outs) adn sound became very distorted with alot of white noise in the back round. After I "tuned"the line outs the sound quality is great ( I think much better than factory )

I also had an issue fitting it all back there. I ended up not screwing back in the lower HVAC control box and place the PAC in that area. I then put that beige box somewhere else. It all fit better.

JACKPAC · 02-14-2011, 10:53 AM

Thanks guys! It's always better to have everything you need before you start a project like this.

JACKPAC · 02-14-2011, 05:07 PM

Interestingly enough, as I was asking you guys about the LOC, I also emailed Crutchfield with the same question. The guy told me all I would need to get it to work right was:
Nissan/Subaru Receiver Wire Harness For select 2007-up Nissan and 2010-up Subaru models at Crutchfield.com

You'd think if there were HU's frying right and left from bad installs, they would know about it.

I'll probably still pick up one to be safe. I remember in my old RSX, I just bypassed the BOSE amp entirely.

toxik · 02-14-2011, 05:37 PM

here's what it looks like when it's all said and done:

diablokev87 · 02-14-2011, 05:40 PM

Once i get some time to install the steering wheel button stuff, ill also take some picture.

toxik · 02-14-2011, 05:47 PM

Quote:

Originally Posted by diablokev87

Once i get some time to install the steering wheel button stuff, ill also take some picture.

yeah please let us know asap on that one, i'm still waiting for you haha

diablokev87 · 02-14-2011, 05:56 PM

Quote:

Originally Posted by toxik

yeah please let us know asap on that one, i'm still waiting for you haha

Sorry dude.. so damn busy. Been doing a lot of OWASP presentations, and getting another one ready for Source Boston. And i need to start to figure out what to do for Blackhat... The hacking business is some good business.
</thread hijack>

diablokev87 · 02-14-2011, 05:56 PM

Quote:

Originally Posted by toxik

yeah please let us know asap on that one, i'm still waiting for you haha

Sorry dude.. so damn busy. Been doing a lot of OWASP presentations, and getting another one ready for Source Boston. And i need to start to figure out what to do for Blackhat... The hacking business is some good business.
</thread hijack>

toxik · 02-14-2011, 08:39 PM

Quote:

Originally Posted by diablokev87

Sorry dude.. so damn busy. Been doing a lot of OWASP presentations, and getting another one ready for Source Boston. And i need to start to figure out what to do for Blackhat... The hacking business is some good business.
</thread hijack>

i envy your line of work.

chirowolf · 02-15-2011, 10:24 AM

Quote:

Originally Posted by JACKPAC

Interestingly enough, as I was asking you guys about the LOC, I also emailed Crutchfield with the same question. The guy told me all I would need to get it to work right was:
Nissan/Subaru Receiver Wire Harness For select 2007-up Nissan and 2010-up Subaru models at Crutchfield.com

You'd think if there were HU's frying right and left from bad installs, they would know about it.

I'll probably still pick up one to be safe. I remember in my old RSX, I just bypassed the BOSE amp entirely.

I think the install would have been OK without the PAC for awhile, but over time I think problems would developed. The PAC also gives you more tuning and volume control. For $30 it was worth the extra time for the install and fitting.
When you order your wiring harness make sure it has a orange wire(not all do ) the orange wire is for day/night illumination for your new radio or auto dimming for night time. you can do without it but those touch screens can get pretty bright at night..
I actually picked up 2 wiring harnesses so I could pull some pins out of the extra harness and plug them in to the harness I would use for my install. this made installing the Axxess steering wheel controller much easier. i did not have to cut into the factory harness at all, just made sure I labeled the new pins on my aftermarket harnes to match up with the facory harness steering whell controlls. all wiring could be basicallly done outside the car and just plugged in during the install.

toxik · 03-08-2011, 09:08 PM

bump, has anyone been able to get the Metra ASWC to work with the Bose system? How was the wiring done?

chirowolf · 03-09-2011, 09:54 AM

hope this comes through and may have been posted before, but this is the correct pin out for the Z. Axxess site is incorrect. If you want your access steering wheel controls work use the attached diagram for your Z wiring harness.

bigaudiofanat · 03-09-2011, 10:04 AM

Sorry that does not help, that is what I have wired all the bose systems to for the metra and got nothing.

02-14-2011, 05:07 PM	#35 (permalink)
JACKPAC Track Member Join Date: Sep 2009 Location: Kentucky Posts: 516 Drives: MB 370z Rep Power: 17	Interestingly enough, as I was asking you guys about the LOC, I also emailed Crutchfield with the same question. The guy told me all I would need to get it to work right was: Nissan/Subaru Receiver Wire Harness For select 2007-up Nissan and 2010-up Subaru models at Crutchfield.com You'd think if there were HU's frying right and left from bad installs, they would know about it. I'll probably still pick up one to be safe. I remember in my old RSX, I just bypassed the BOSE amp entirely. Last edited by JACKPAC; 02-14-2011 at 05:11 PM.

02-14-2011, 05:40 PM	#37 (permalink)
diablokev87 Base Member Join Date: Aug 2009 Location: Queens NY Posts: 246 Drives: 09 Niss 370Z Blue A7 Rep Power: 16	Once i get some time to install the steering wheel button stuff, ill also take some picture. __________________ 2009 370z (AT7): Gen3 \| HKS Hi Power \| Z120BT \| Animated Foglight \| 590.2x 1999 Maxima SE (MT5): Nada (so far)

03-09-2011, 10:04 AM	#45 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	Sorry that does not help, that is what I have wired all the bose systems to for the metra and got nothing. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
For those who installed aftermarket speakers w/ the stock headunit	STi 5	Audio & Video	24	09-17-2012 11:30 PM
FS: Bose Speakers & Sub	370book	Parts for sale (Private Classifieds)	1	04-11-2010 02:05 AM
PLEASE HELP!!! Rear deck lid emblems..WTB!	C3Killer	Parts for sale (Private Classifieds)	9	10-13-2009 12:54 AM
Recommend an MP3 head unit and decent speakers for non BOSE 370z!	steven88	Audio & Video	16	09-14-2009 06:56 PM
Door Speakers Bose w/o Nav Pics	jikhead	Audio & Video	6	07-21-2009 09:48 AM

02-14-2011, 10:53 AM	#34 (permalink)
JACKPAC Track Member Join Date: Sep 2009 Location: Kentucky Posts: 516 Drives: MB 370z Rep Power: 17	Thanks guys! It's always better to have everything you need before you start a project like this.