Stick mp3 player to base cubby shell?

CharlieFoxtro · 03-29-2010, 08:40 PM

USNA94;

Thanks. That's sort of what I initially tried. I used cushion foam and tried to shape it to fit the cubby and cut a frame into it to hold the GPS unit. It didn't work out too well. Trying to cut intricate shapes into foam with an electric carving knife was just a bit too difficult!

I don't remember exactly how I got the power cable to the back of the cubby. I removed some of the console trim but I'm not sure whether it was really necessary to do so. I drilled the hole in the back of the cubby and then used what I had on hand, a venetian blind adjustment rod (a wooden dowel would do), pushed it through the hole until it poked out past the trim forward on the transmission hump, attached a string to it and pulled the string back to the hole in the cubby. Then I attached the power cord to the string at the transmission hump and pulled it through. I would have gone to the fuse panel for power but I didn't have a mini fuse tap on hand. I did have wire taps, so I tapped power and ground from the wires for the passenger 12VDC socket.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ARC 370Z (Fairlady Z34) with interesting cubby hole device	AK370Z	Exterior & Interior	12	05-20-2010 05:04 PM
FS: FACTORY CD PLAYER IN 09 370z Base	d4k0t4	Parts for sale (Private Classifieds)	0	12-20-2009 09:55 PM
Which fuel is better Shell or BP?	ricky bobby	Nissan 370Z General Discussions	18	12-04-2009 05:02 PM
350z shell	protoZ	Wanted	0	10-23-2009 10:50 PM
How many like 6MT but cant drive stick?	Supragtsxr	Nissan 370Z General Discussions	48	09-14-2009 11:20 PM

03-29-2010, 08:40 PM	#22 (permalink)
CharlieFoxtro Base Member Join Date: Feb 2009 Location: Raleigh, NC Posts: 24 Drives: 09 Nissan 370Z BS M6 Rep Power: 17	USNA94; Thanks. That's sort of what I initially tried. I used cushion foam and tried to shape it to fit the cubby and cut a frame into it to hold the GPS unit. It didn't work out too well. Trying to cut intricate shapes into foam with an electric carving knife was just a bit too difficult! I don't remember exactly how I got the power cable to the back of the cubby. I removed some of the console trim but I'm not sure whether it was really necessary to do so. I drilled the hole in the back of the cubby and then used what I had on hand, a venetian blind adjustment rod (a wooden dowel would do), pushed it through the hole until it poked out past the trim forward on the transmission hump, attached a string to it and pulled the string back to the hole in the cubby. Then I attached the power cord to the string at the transmission hump and pulled it through. I would have gone to the fuse panel for power but I didn't have a mini fuse tap on hand. I did have wire taps, so I tapped power and ground from the wires for the passenger 12VDC socket.