How to setup crossover frequencies etc

RonRizz

because you are using the polk passive crossover, you should have it set to standard mode, otherwise, ditch the passive crossover, and wire the woofer and tweeter to head unit mid and high outputs, then run in network mode, and use your digital crossover.

__________________
P99rs Head Unit--- Amps- 2 Pioneer Prs800d --- Zapco ST1000MX---Zapco ST-4XSQ---- SI BM mk5 Subs---SI TM65v2 Midbass--- SI M3 mids--- SI M25 xbl2 tweeters ----- 2016 MECA street class 3rd place at world finals

Djvalerio921

Hmmm ok. What should I wire the tweeters to? The same as the woofer? I don't believe I have the mid an high outputs.. LOL newbie here

RonRizz

Check your manual. when in network mode, your speaker outputs will be... Rear changes to Mid (for woofers) and Front changes to High (for tweeters) I believe.

__________________
P99rs Head Unit--- Amps- 2 Pioneer Prs800d --- Zapco ST1000MX---Zapco ST-4XSQ---- SI BM mk5 Subs---SI TM65v2 Midbass--- SI M3 mids--- SI M25 xbl2 tweeters ----- 2016 MECA street class 3rd place at world finals

Jayhovah

As as aside... I just ordered a pioneer head unit after I discovered the existence of network mode. It's a feature I have wanted for many years!!!

I previously didn't consider the pioneers because they don't have a volume knob... but I had to have the network mode, particularly since I want to drive the front speakers off the HU.

Does anyone happen to know where the factory speaker crossover point is?

__________________
2013 Gun Metallic Sport - Gamma V3 Twin Turbogized
DIY Gamma V3 TT Install * Jayhovah's Gamma V3 TT Install Pic'Z and Vid'Z * DIY: Washer Reservoir for the Boosted

bigaudiofanat

Yep this

__________________
Need help with car audio or electronics? Let me know!! Need Help Let Me Know
Direct email address reimermatt@gmail.com
Owner of: Dynamic Mobile Audio Follow me below
https://www.facebook.com/Dynamicmobileaudio/