I am thinking of buying an amp; Suggestions?

TNBXIII · 06-30-2016, 10:38 AM

Hello Guys,
Sorry to bother you guys once again with my newbie questions.

As you all know by know I am going to upgrade my car audio system. I already bought the speakers and head unit, but I think an amp would be a great addition if I am going to do a full audio install.

Here are my specs:
Pioneer FH-X830BHS
RMS Power Output 14 watts
Peak Output 50 watts
RMS Power Bandwidth 20-20kHz
Preamp Outputs 6-channel
Sub Preamp Outputs Yes

Alpine SPR-50C
Sensitivity 87 dB
Frequency Response 70 - 29k Hz
RMS Power Range (Watts) 8-100
Peak Power Handling (Watts) 300
Impedance (Ohms) 4

What do you guys think would a be a great amp to power this speakers?
Also if would be great if you could suggest something that could fit under the seat, or somewhere where it does not take too much space and has no risk of heating up.

Thank you guys, and sorry for all the trouble.

RonRizz · 06-30-2016, 05:46 PM

Tons of great amps out there.... I would suggest a nice 4 channel, and you can use the head units crossover feature to split the tweeters and woofers between front and rear channels. Budget would be the next question.

TNBXIII · 06-30-2016, 08:46 PM

Quote:

Originally Posted by RonRizz

Tons of great amps out there.... I would suggest a nice 4 channel, and you can use the head units crossover feature to split the tweeters and woofers between front and rear channels. Budget would be the next question.

Thank you for the reply and advice Ron. As for my budget, around 200 hundrish would be ideal. I could probably push it a bit more for something a whole lot better.

white37014 · 06-30-2016, 10:42 PM

Not trying to hijack the thread but how about an amp for two front component speakers and one single sub in the rear not so much the exact amp but how many channels? I was looking at a 3 channel any thoughts?

TNBXIII · 07-01-2016, 04:12 PM

So, I was looking at some amps and I was thinking of getting the Rockford Fosgate Punch P300X2.

I think I was able to match the amp to my speakers based on what I read online. Could anybody confirm if this amp is good enough for my speakers? I do not want to overpower them.

Amp specs:
RMS Power Output (Watts x Channels) 100 x 2
Peak Power Output (Watts x Channels) N/A
Power at 2 Ohms (Watts x Channels) 150 x 2
Bridged Power (Watts x Channels) 300 x 1
Minimum Impedance Bridged 4
Minimum Impedance Unbridged 2
Best Frequency Response 20-20k Hz
THD at Rated RMS Power 1%
Signal to Noise Ratio 85 dB
Input Voltage

RonRizz · 07-01-2016, 08:46 PM

Quote:

Originally Posted by TNBXIII

So, I was looking at some amps and I was thinking of getting the Rockford Fosgate Punch P300X2.

I think I was able to match the amp to my speakers based on what I read online. Could anybody confirm if this amp is good enough for my speakers? I do not want to overpower them.

Amp specs:
RMS Power Output (Watts x Channels) 100 x 2
Peak Power Output (Watts x Channels) N/A
Power at 2 Ohms (Watts x Channels) 150 x 2
Bridged Power (Watts x Channels) 300 x 1
Minimum Impedance Bridged 4
Minimum Impedance Unbridged 2
Best Frequency Response 20-20k Hz
THD at Rated RMS Power 1%
Signal to Noise Ratio 85 dB
Input Voltage

That amp will do just fine

RonRizz · 07-01-2016, 08:47 PM

Quote:

Originally Posted by white37014

Not trying to hijack the thread but how about an amp for two front component speakers and one single sub in the rear not so much the exact amp but how many channels? I was looking at a 3 channel any thoughts?

or you could do a 4 channel, and bridge the 2 rear channels to your sub, or run a dual voice coil sub.

solo413 · 07-01-2016, 10:55 PM

You could also just get a mono amp for a sub

Jayhovah · 07-01-2016, 11:00 PM

There are also three channel amps... I have one (JBL GTO3EZ) I bought for my 2011.... though I am considering not installing it in the 2013. Not sure I wan't to add the big amp/sub weight (the RE SCX 10" I got is hefty). Might get one of those small amped sub combos or something instead.

white37014 · 07-02-2016, 06:06 PM

Thanks all, waiting for my new deck to come in and once I get it installed depending on how the stock speakers sound will be the deciding factor. If speakers are good enough for my taste prob will go will mono app and single sub in magic box. I am trying to not have to install two amps if I end up going with component speakers up front and a single sub in the rear.

RumbleFish · 07-02-2016, 07:09 PM

Alpine PDX-V9 is a nice 5 ch. amp.

100 watts RMS x 4 + 500 watts RMS x 1 at 2 or 4 ohms
or
200 watts x 2 bridged at 4 ohms + 500 watts x 1 (for sub)

I'm happy with it

white37014 · 07-02-2016, 09:57 PM

Quote:

Originally Posted by RumbleFish

Alpine PDX-V9 is a nice 5 ch. amp.

100 watts RMS x 4 + 500 watts RMS x 1 at 2 or 4 ohms
or
200 watts x 2 bridged at 4 ohms + 500 watts x 1 (for sub)

I'm happy with it

That sounds impressive, so you could take a 5 channel and bridge the 4 channels into 2 and run the last one for sub? That don't sound like a bad option ether.

solo413 · 07-02-2016, 10:30 PM

This is the set up I'm going with I'm happy with the front speakers just want to add back speakers and the mono amp and shallow mount sub

TNBXIII · 07-04-2016, 07:39 PM

Update:
I have not bought the amp just yet.
Does anybody know if the Alpine KTP-445U power pack is any good?
I saw multiple good reviews online, but I have not come across anyone that has a 370z.
If any of you have it, is it any good, and if so, where did you put it?

bigaudiofanat · 07-05-2016, 08:46 AM

They are ok, you have to give them air circulation behind the head unit. I have done a few in the z's with no issue.

06-30-2016, 10:38 AM	#1 (permalink)
TNBXIII Base Member Join Date: Nov 2015 Location: Palm Beach Posts: 40 Drives: 12 Nissan 370Z M6 Rep Power: 10	I am thinking of buying an amp; Suggestions? Hello Guys, Sorry to bother you guys once again with my newbie questions. As you all know by know I am going to upgrade my car audio system. I already bought the speakers and head unit, but I think an amp would be a great addition if I am going to do a full audio install. Here are my specs: Pioneer FH-X830BHS RMS Power Output 14 watts Peak Output 50 watts RMS Power Bandwidth 20-20kHz Preamp Outputs 6-channel Sub Preamp Outputs Yes Alpine SPR-50C Sensitivity 87 dB Frequency Response 70 - 29k Hz RMS Power Range (Watts) 8-100 Peak Power Handling (Watts) 300 Impedance (Ohms) 4 What do you guys think would a be a great amp to power this speakers? Also if would be great if you could suggest something that could fit under the seat, or somewhere where it does not take too much space and has no risk of heating up. Thank you guys, and sorry for all the trouble.

06-30-2016, 05:46 PM	#2 (permalink)
RonRizz A True Z Fanatic Join Date: Aug 2011 Location: Pine grove, Pa Posts: 2,136 Drives: 2 feet, 3 pedals Rep Power: 6775	Tons of great amps out there.... I would suggest a nice 4 channel, and you can use the head units crossover feature to split the tweeters and woofers between front and rear channels. Budget would be the next question. SouthArk370Z and TNBXIII like this. __________________ P99rs Head Unit--- Amps- 2 Pioneer Prs800d --- Zapco ST1000MX---Zapco ST-4XSQ---- SI BM mk5 Subs---SI TM65v2 Midbass--- SI M3 mids--- SI M25 xbl2 tweeters ----- 2016 MECA street class 3rd place at world finals

07-02-2016, 07:09 PM	#11 (permalink)
RumbleFish Premium Member Join Date: Oct 2013 Location: Los Feliz, Ca. Posts: 1,212 Drives: '10-Sport-M6 Rep Power: 8240	Alpine PDX-V9 is a nice 5 ch. amp. 100 watts RMS x 4 + 500 watts RMS x 1 at 2 or 4 ohms or 200 watts x 2 bridged at 4 ohms + 500 watts x 1 (for sub) I'm happy with it __________________ How far, this...Utopia? F.I. CBE V2/Stillen G3 CAI/GTM 25R OC/EcuTek tune (Specialty Z)/ KW V3's/Stillen Sway bars/SPC rear camber kit/Z1 FUCA/Mich. PSS4S 255/35-295/30

07-05-2016, 08:46 AM	#15 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	They are ok, you have to give them air circulation behind the head unit. I have done a few in the z's with no issue. TNBXIII likes this. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Thinking about buying a 300zx TT	madwi	Other Vehicles	19	09-09-2013 01:31 AM
Thinking of buying a Z	homeryansta	Nissan 370Z Pricing / Ordering Discussions	16	03-15-2012 10:00 AM
Thinking of selling and buying	Nikon FM	Nissan 370Z General Discussions	88	10-20-2011 08:14 AM
Thinking of buying the 370Z..?	chris2kmac	Nissan 370Z General Discussions	5	06-08-2011 01:16 PM
Thinking about buying a Z	mikecho	New Forum Member	2	02-21-2010 05:33 AM

06-30-2016, 10:42 PM	#4 (permalink)
white37014 Base Member Join Date: May 2014 Location: Pa Posts: 114 Drives: 14 370 base sport 6t Rep Power: 11	Not trying to hijack the thread but how about an amp for two front component speakers and one single sub in the rear not so much the exact amp but how many channels? I was looking at a 3 channel any thoughts?

07-01-2016, 04:12 PM	#5 (permalink)
TNBXIII Base Member Join Date: Nov 2015 Location: Palm Beach Posts: 40 Drives: 12 Nissan 370Z M6 Rep Power: 10	So, I was looking at some amps and I was thinking of getting the Rockford Fosgate Punch P300X2. I think I was able to match the amp to my speakers based on what I read online. Could anybody confirm if this amp is good enough for my speakers? I do not want to overpower them. Amp specs: RMS Power Output (Watts x Channels) 100 x 2 Peak Power Output (Watts x Channels) N/A Power at 2 Ohms (Watts x Channels) 150 x 2 Bridged Power (Watts x Channels) 300 x 1 Minimum Impedance Bridged 4 Minimum Impedance Unbridged 2 Best Frequency Response 20-20k Hz THD at Rated RMS Power 1% Signal to Noise Ratio 85 dB Input Voltage

07-01-2016, 10:55 PM	#8 (permalink)
solo413 Base Member Join Date: May 2016 Location: bear, DE Posts: 107 Drives: 13 370z pearl manual Rep Power: 43	You could also just get a mono amp for a sub

07-02-2016, 06:06 PM	#10 (permalink)
white37014 Base Member Join Date: May 2014 Location: Pa Posts: 114 Drives: 14 370 base sport 6t Rep Power: 11	Thanks all, waiting for my new deck to come in and once I get it installed depending on how the stock speakers sound will be the deciding factor. If speakers are good enough for my taste prob will go will mono app and single sub in magic box. I am trying to not have to install two amps if I end up going with component speakers up front and a single sub in the rear.

07-02-2016, 10:30 PM	#13 (permalink)
solo413 Base Member Join Date: May 2016 Location: bear, DE Posts: 107 Drives: 13 370z pearl manual Rep Power: 43	This is the set up I'm going with I'm happy with the front speakers just want to add back speakers and the mono amp and shallow mount sub

07-04-2016, 07:39 PM	#14 (permalink)
TNBXIII Base Member Join Date: Nov 2015 Location: Palm Beach Posts: 40 Drives: 12 Nissan 370Z M6 Rep Power: 10	Update: I have not bought the amp just yet. Does anybody know if the Alpine KTP-445U power pack is any good? I saw multiple good reviews online, but I have not come across anyone that has a 370z. If any of you have it, is it any good, and if so, where did you put it?